imgalt

GOST 20910-90

ГОСТ 20910-90

Refractory concretes. Specifications

Бетоны жаростойкие. Технические условия

Status: Valid - In exchange for 09/01/2019

The standard applies to heat-resistant concretes intended for use at operating temperatures up to 1800 degrees. C. The requirements of this standard should be observed in the development of new, revision of existing standards, technical conditions, design and technological documentation and in the production of precast concrete and reinforced concrete products and structures, monolithic and precast monolithic structures of these concrete. The standard does not apply to refractory concretes.

Стандарт распространяется на жаростойкие бетоны, предназначенные для применения при эксплуатационных температурах до 1800 град. С. Требования настоящего стандарта следует соблюдать при разработке новых, пересмотре действующих стандартов, технических условий, проектной и технологической документации и при производстве сборных бетонных и железобетонных изделий и конструкций, монолитных и сборно-монолитных сооружений из этих бетонов. Стандарт не распространяется на огнеупорные бетоны.

Choose Language: 
Format: Electronic (pdf/doc)

Approved: State Committee of the Council of Ministers of the USSR for Construction, 10/12/1990

SKU: RUSS17907

Price: $398.00



imgalt

The Product is Contained in the Following Classifiers:

Construction (Max) » Regulations » Documents System of normative documents in construction » 6. Regulatory documents for building materials and products » k.62 Concretes and mortars »

ISO classifier » 91 CONSTRUCTION MATERIALS AND CONSTRUCTION » 91.100 Building Materials » 91.100.30 Concrete and concrete products »

National standards » 91 CONSTRUCTION MATERIALS AND CONSTRUCTION » 91.100 Building Materials » 91.100.30 Concrete and concrete products »

National Standards for KGS (State Standards Classification) » Latest edition » Zh Construction and building materials » Zh1 Construction materials » Zh13 Concretes and mortars »


The Document is Replaced With:

GOST 20910-2019: Concrete is heat-resistant. Technical specifications

As a Replacement Of:

GOST 20910-82: Refractory concretes. Specifications

GOST 20955-75: Fillers for heat-resistant concrete. Classification and technical requirements

GOST 20956-75: Fine-grained additives for heat-resistant concrete. Classification and technical requirements

GOST 23283-78: Refractory concretes. Determination of deformation under load at high temperatures

GOST 23521-79: Structures and products of concrete and reinforced concrete from heat-resistant concrete. General specifications

The Document References:

GOST 10060.0-95: Methods for the determination of frost-resistance. General requirements

GOST 10060-87: Concretes. Methods of frost resistance determination

GOST 10178-85: Portland cement and portland blastfurnace slag cement. Specifications

GOST 10180-90: Concretes. Methods for strength determination using reference specimens

GOST 10181.0-81: Concrete mixtures. General requirement to test methods

GOST 10181.1-81: Concrete mixture. Test method of determination of workability

GOST 10181-2000: Concrete Mixtures Test method

GOST 10832-91: Expanded pearlite sand and crushed stone. Specifications

GOST 12730.2-78: Concretes. Method of determination of moisture content

GOST 12730.5-84: Concretes. Methods for determination of water tightness

GOST 12865-67: Expanded vermiculits.

GOST 13015.1-81: Prefabricated concrete and reinforced concrete constructions and products. Acceptance

GOST 13078-81: Sodium glass liquid. Technical conditions

GOST 13079-93: Sodium silicate soluble. Technical conditions

GOST 13646-68: Glass mercury thermometers designed for precise measurements

GOST 14828-69: Instruments for physical-chemical quantities measurement. Radiospectrometers. Terms

GOST 18105-86: Concretes. Rules for the strength control

GOST 18481-81: Glass hydrometers and cylinders. General specifications

GOST 20419-83: Ceramic electrotechnical materials

GOST 22685-89: Moulds for making control specimens of concrete. Specifications

GOST 23037-99: Refractory fillers. Technical conditions

GOST 23732-79: Water for concretes and mortars. Specifications

GOST 24104-2001: Laboratory scales. General technical requirements

GOST 24104-88: General purpose and reference laboratory balances

GOST 25485-89: Cellular concretes. Specifications

GOST 25592-91: Mixes of fly-ash and slag of thermal plants for concretes. Specifications

GOST 26134-84: Concretes. Ultrasonic method of frost resistance determination

GOST 2642.0-86: Refractories and refractory raw materials. General requirements for methods of analysis

GOST 2642.10-86: Refractories and refractory raw materials. Methods for the determination of phosphorus pentoxide

GOST 2642.11-97: Refractories and refractory raw materials. Method for determination of potassium and sodium oxides

GOST 2642.12-97: Refractories and refractory raw materials. Methods for the determination of manganese (II) oxide

GOST 2642.1-86: Refractories and refractory raw materials. Method for the determination of hygroscopic moisture

GOST 2642.2-86: Refractories and refractory raw materials. Methods for the determination of mass change ignition

GOST 2642.3-97: Refractories and refractory raw materials. Methods for the determination of silicon (IV) oxide

GOST 2642.4-97: Refractories and refractory raw materials. Methods for the determination of aluminium oxide

GOST 2642.5-97: Refractories and refractory raw materials. Methods for the determination of iron (III) oxide

GOST 2642.6-97: Refractories and refractory raw materials. Methods for the determination of titanium (IV) oxide

GOST 2642.7-97: Refractories and refractory raw materials. Methods for determination of calcium oxide

GOST 2642.8-97: Refractories and refractory raw materials. Methods for the determination of magnesium oxide

GOST 2642.9-97: Refractories and refractory raw materials. Methods for the determination of chrome (III) oxide

GOST 27005-86: Light-weight and cellular concretes. Rules of average density control

GOST 310.2-76: Cements. Methods of grinding fineness determination

GOST 5578-94: Slag crushed stone and slag sand of ferrous and non-ferrous metallurgy for concretes. Specifications

GOST 7473-94: Ready-mixed concrete. Specifications

GOST 8335-81: Visual pyrometers with disappearing filament

GOST 969-91: Alumina and high alumina cements. Specifications

GOST 9757-90: Artificial porous gravel, crushed stone and sand artificially produced expanded/foamed gravel, crushed rock and sand]. Specifications

GOST 9758-86: Non-organic porous aggregates for construction work

OSP-72/87: Basic sanitary rules for working with radioactive substances and other sources of ionizing radiation

ST SEV 1406-78: Concrete and reinforced concrete structures. Basic provisions in design

TU 21-20-60-84: High-alumina cement of aluminothermic production

TU 25-02.792301-80: Thermoelectric converters TPP-0679, TP-0679, TPR-0779

TU 63-156-1-83: Refractory and abrasive scrap

The Document is Referenced By:

GOST 13015-2003: Concrete and reinforced concrete products for construction. General technical requirements. Rules for acceptance, marking, transportation and storage

GOST 13015-2012: Concrete and reinforced concrete products for construction. General technical requirements. Rules for acceptance, marking, transportation and storage

GOST 23009-2016: Prefabricated concrete and reinforced concrete constructions and products. Symbols (marks)

GOST 23009-78: Prefabricated concrete and reinforced concrete constructions and products. Symbols (marks)

GOST 25628.1-2016: Reinforced concrete columns for single-storey industrial buildings. Specifications

GOST 25818-2017: Fly ash thermal power plants for concrete. Technical conditions

GOST 25818-91: Thermal plant fly-ashes for concretes. Specifications

GOST 34518-2019: Industrial furnaces and thermal units. Rules for the organization and production of work, monitoring of performance and requirements for the results of work

GOST 34519-2019: Industrial chimney and ventilation pipes. Rules for the organization and production of work, monitoring of performance and requirements for the results of work

GOST R 53682-2009: Fired heaters for refineries. General technical requirements

GOST R 57384-2017: Secure storage device. Fire resistance safes and cabinets. Classification and methods of fire resistance tests

RB-005-98: Requirements to Certification of Building Structures Important for Safety of Nuclear Facilities

RD 34.26.203: Guidelines for Brick Lining Work During Installation of Boiler Plants and Energy Facilities

SN 156-79: Instructions on the technology of preparation of heat-resistant concrete

SNiP 3.09.01-85: Precast reinforced concrete structure and work-piece production

SNiP 52-01-2003: Concrete and ferroconcrete structures. Principal rules

SP 27.13330.2011: Concrete and Reinforced Concrete Structures intended for the Service in Elevated and High Temperatures

SP 27.13330.2017: Concrete and reinforced concrete structures intended for the service in elevated and high temperatures

SP 52-104-2006: Steel fibre reineorced concrete structures

SP 52-110-2009: Concrete and reinforced concrete structures subjected to technological high and high temperatures

SP 70.13330.2012: Bearing and enclosing structures. Updated living edition of SNiP 3.03.01-87

SP 83.13330.2016: Industrial furnaces and brick chimneys

Customers Who Viewed This Item Also Viewed:

imgalt imgalt
Tight and slack wooden barrels
Language: English
Price: $349.00
imgalt
Cylindrical evolvent gears of external engagment. Strength calculation
Language: English
Price: $745.00
imgalt
Software for measuring instruments. Procedure for of certification. General provisions
Language: English
Price: $356.86
imgalt
Vegetable oils. General technical requirements
Language: English
Price: $461.10
imgalt
Current transformers. General specifications
Language: English
Price: $715.00
imgalt

YOUR ORDERING MADE EASY!

RussianGost.com is an industry-leading company with stringent quality control standards and our dedication to precision, reliability and accuracy are some of the reasons why some of the world’s largest companies trust us to provide their national regulatory framework and for translations of critical, challenging, and sensitive information.

Our niche specialty is the localization of national regulatory databases involving: technical norms, standards, and regulations; government laws, codes, and resolutions; as well as RF agency codes, requirements, and Instructions.

We maintain a database of over 220,000 normative documents in English and other languages for the following 12 countries: Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Mongolia, Russia, Tajikistan, Turkmenistan, Ukraine, and Uzbekistan.

Placing Your Order

Please select your chosen document, proceed to the ‘checkout page’ and select the form of payment of your choice. We accept all major credit cards and bank wire transfers. We also accept PayPal and Google Checkout for your convenience. Please contact us for any additional arrangements (Contract agreements, PO, etc.).

Once an order is placed it will be verified and processed within a few hours up to a rare maximum of 24 hours.

For items in stock, the document/web link is e-mailed to you so that you can download and save it for your records.

For items out of stock (third party supply) you will be notified as to which items will require additional time to fulfil. We normally supply such items in less than three days.

Once an order is placed you will receive a receipt/invoice that can be filed for reporting and accounting purposes. This receipt can be easily saved and printed for your records.

Your Order Best Quality and Authenticity Guarantee

Your order is provided in electronic format (usually an Adobe Acrobat or MS Word).

We always guarantee the best quality for all of our products. If for any reason whatsoever you are not satisfied, we can conduct a completely FREE revision and edit of products you have purchased. Additionally we provide FREE regulatory updates if, for instance, the document has a newer version at the date of purchase.

We guarantee authenticity. Each document in English is verified against the original and official version. We only use official regulatory sources to make sure you have the most recent version of the document, all from reliable official sources.

All Codes and Regulations

All Categories

Send us a message Expand Collapse

Leave your message in the form below, and we will write back by e-mail!