imgalt

VSN 004-88

ВСН 004-88

Construction of trunk pipelines. Technology and management.

Строительство магистральных трубопроводов. Технология и организация

Status: Effective

Standards apply to the construction of underground trunk steel pipelines with a diameter of up to 1,420 mm (inclusive) with an overpressure of no more than 10 MPa. The requirements of this regulatory document apply to the production, control and acceptance of preparatory and main works (earthworks, loading and unloading, transport, storage, insulation and laying) for the construction of the linear part of main pipelines. The requirements of the regulatory document do not apply to the construction of trunk pipelines in the marine areas and in areas with seismicity over 8 points for underground and over 6 points for above-ground pipelines. In these cases, special requirements for the production and acceptance of work, regulated by the project, must be observed.

Нормы распространяются на сооружение подземных магистральных стальных трубопроводов диаметром до 1420 мм (включительно) с избыточным давлением не выше 10 МПа. Требования настоящего нормативного документа распространяются на производство, контроль и приемку работ подготовительного и основного (земляные, погрузочно-разгрузочные, транспортные, складские, изоляционно-укладочные работы) периодов строительства линейной части магистральных трубопроводов. Требования нормативного документа не распространяются на строительство магистральных трубопроводов на морских акваториях и в районах с сейсмичностью свыше 8 баллов для подземных и свыше 6 баллов для надземных трубопроводов. В этих случаях должны соблюдаться специальные требования к производству и приемке работ, регламентированные проектом.

Choose Language: 
Format: Electronic (pdf/doc)

Approved: Minneftegazstroy, 12/1/1988

SKU: RUSS19932

Price: $773.00

imgalt

The Product is Contained in the Following Classifiers:

Construction (Max) » Regulations » Sectoral and departmental regulatory and methodological documents » Design and construction of oil and gas industry facilities »

Welding regulations » Welding work »

Welding regulations » Pipelines »

Welding regulations » Welding materials »

Welding regulations » welding equipment »

Welding regulations » Documentation »

Welding regulations » Assembly devices »

Welding regulations » Welding work » Dusting »

Welding regulations » Welding materials » Wire »

PromExpert » SECTION V. ENVIRONMENTAL PROTECTION. NATURE USE » II Ensuring environmental safety » 4 Ensuring environmental safety during subsoil use » 4.2 Use and protection of subsoil » 4.2.4 Environmental safety requirements in design, installation and operation of submarine cables and pipelines »

ISO classifier » 13 ENVIRONMENTAL PROTECTION, HUMAN PROTECTION AGAINST ENVIRONMENTAL IMPACT. SECURITY » 13.080 The quality of soil. Soil science » 13.080.01 Soil quality and soil science in general »

ISO classifier » 13 ENVIRONMENTAL PROTECTION, HUMAN PROTECTION AGAINST ENVIRONMENTAL IMPACT. SECURITY » 13.080 The quality of soil. Soil science » 13.080.99 Soil quality, other aspects »

ISO classifier » 75 EXTRACTION AND PROCESSING OF OIL, GAS AND RELATED PRODUCTION » 75.200 Equipment for oil refining, oil products and natural gas » 2003.200.13 Pipelines and their components »


The Document is Replaced With:

SP 34-112-97: Construction of Trunk Pipelines and Flowlines. Integrated Technology and Organization

As a Replacement Of:

VSN 179-85: Guidelines for the Remediation of Lands Used for the Construction of Pipelines

VSN 197-86: Instructions for the inter-object stage specialization of works in the construction of the linear part of trunk pipelines

VSN 2-135-81: Instructions on the technology and organization of transportation, loading, unloading and storage of large diameter pipes during the construction of oil and gas pipelines

VSN 2-149-82: Instructions for the production of works in the construction of trunk steel pipelines. Insulation work

The Document References:

RD 102-63-87: Method of designing storage of large diameter pipes.

SNiP 3.01.03-84: Survey operations in construction

VSN 51-1-80: Guidelines for Construction Practices Within Safety Zones of Trunk Pipelines Administered by the Ministry of the Gas Industry

The Document is Referenced By:

RD 153-112TNP-027-97: Guidelines for Cold-Weather Overhaul of Petroleum Product Pipelines 100-720 mm in Diameter

RD 153-39.4-044-99: Rules of total overhaul of main oil product pipelines laid in the cities, settlements and entering the territory of tank farms and pumping stations

RD 153-39.4-056-00: Main crude pipeline. Operations rules.

RD 153-39.4-075-01: Rules of maintenance overhaul of oil-trunk pipeline at waterway, railway and category I-IV highway crossings.

RD 39-132-94: Regulations for Operation, Inspection, Repair and Rejection of the Field Pipelines 1994

RD 51-2.4-007-97: Protection of Soils against Water Erosion in Locations of Linear Sections of Pipelines

SP 103-34-96: SPSMG. A set of rules on the construction of the linear part of the pipeline. Preparation of the construction strip. RAO "Gazprom", 01/10/96

SP 104-34-96: SPSMG. A set of rules on the construction of the linear part of the pipeline. Performing excavation. RAO "Gazprom", 01/10/96

SP 108-34-97: SPSMG. The construction of underwater passages. RAO "Gazprom", 01/08/98

SP 34-112-97: Construction of Trunk Pipelines and Flowlines. Integrated Technology and Organization

SP 34-116-97: Instructions For Design, Construction and Redesign of Field Oil and Gas Pipelines

SP 422.1325800.2018: Pipelines trunk and field for oil and gas. Construction of underwater crossings and work control

SP 81.13330.2017: The reclamation systems and construction

VRD 39-1.10-006-2000*: Rules for the technical operation of gas pipelines

VSN 010-88: Construction of main pipelines. Underwater transitions

VSN 51-1-97: Work Execution Requirements for Overhaul of Trunk Pipelines

Customers Who Viewed This Item Also Viewed:

imgalt imgalt
Tight and slack wooden barrels
Language: English
Price: $349.00
imgalt
Cylindrical evolvent gears of external engagment. Strength calculation
Language: English
Price: $745.00
imgalt
Plastics structured-wall pipes and their fittings for sewerage systems outside the buildings. Specifications
Language: English
Price: $606.00
imgalt
Vegetable oils. General technical requirements
Language: English
Price: $461.10
imgalt
Current transformers. General specifications
Language: English
Price: $715.00
imgalt

YOUR ORDERING MADE EASY!

RussianGost.com is an industry-leading company with stringent quality control standards and our dedication to precision, reliability and accuracy are some of the reasons why some of the world’s largest companies trust us to provide their national regulatory framework and for translations of critical, challenging, and sensitive information.

Our niche specialty is the localization of national regulatory databases involving: technical norms, standards, and regulations; government laws, codes, and resolutions; as well as RF agency codes, requirements, and Instructions.

We maintain a database of over 220,000 normative documents in English and other languages for the following 12 countries: Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Mongolia, Russia, Tajikistan, Turkmenistan, Ukraine, and Uzbekistan.

Placing Your Order

Please select your chosen document, proceed to the ‘checkout page’ and select the form of payment of your choice. We accept all major credit cards and bank wire transfers. We also accept PayPal and Google Checkout for your convenience. Please contact us for any additional arrangements (Contract agreements, PO, etc.).

Once an order is placed it will be verified and processed within a few hours up to a rare maximum of 24 hours.

For items in stock, the document/web link is e-mailed to you so that you can download and save it for your records.

For items out of stock (third party supply) you will be notified as to which items will require additional time to fulfil. We normally supply such items in less than three days.

Once an order is placed you will receive a receipt/invoice that can be filed for reporting and accounting purposes. This receipt can be easily saved and printed for your records.

Your Order Best Quality and Authenticity Guarantee

Your order is provided in electronic format (usually an Adobe Acrobat or MS Word).

We always guarantee the best quality for all of our products. If for any reason whatsoever you are not satisfied, we can conduct a completely FREE revision and edit of products you have purchased. Additionally we provide FREE regulatory updates if, for instance, the document has a newer version at the date of purchase.

We guarantee authenticity. Each document in English is verified against the original and official version. We only use official regulatory sources to make sure you have the most recent version of the document, all from reliable official sources.

All Codes and Regulations

All Categories

Send us a message Expand Collapse

Leave your message in the form below, and we will write back by e-mail!