GOST R 51321.1-2000
ГОСТ Р 51321.1-2000
|
|
Low-voltage switchgear and controlgear assemblies. Part 1. Requirements for type-tested and partially type-tested assemblies. General technical requirements and methods of tests
Устройства комплектные низковольтные распределения и управления. Часть 1. Устройства, испытанные полностью или частично. Общие технические требования и методы испытаний
Status: Not effective - Superseded. IUS 11-2008
The standard applies to low-voltage complete distribution and control devices (NKU), fully tested (type tested) - (PI NKU) and partially tested (CHI NKU), the rated voltage of which does not exceed 1000 V AC with a frequency of not more than 1000 Hz or 1500 V direct current, intended for export. The standard also applies to TCU containing control and
Стандарт распространяется на низковольтные комплектные устройства распределения и управления (НКУ), полностью испытанные (прошедшие типовые испытания) - (ПИ НКУ) и частично испытанные (ЧИ НКУ), номинальное напряжение которых не превышает 1000 В переменного тока частотой не более 1000 Гц или 1500 В постоянного тока, предназначенные для экспорта. Стандарт также распространяется на НКУ, содержащие управляющие и/или силовые устройства, работающие при более высоких частотах. В этом случае действуют соответствующие дополнительные требования. Стандарт распространяется на стационарные и передвижные НКУ в защищенном или открытом исполнении. Стандарт распространяется на НКУ управления оборудованием, осуществляющим генерирование, передачу, распределение и преобразование электрической энергии, а также управления оборудованием, потребляющим электрическую энергию. Стандарт также распространяется на НКУ, предназначенные для эксплуатации в особых условиях, например на судах, железнодорожных подвижных средствах, металлорежущих станках, грузоподъемном оборудовании или во взрывоопасной атмосфере и в бытовых условиях (при обслуживании неквалифицированным персоналом), при условии, что соответствующие специальные требования выполняются.
Choose Language:
Format: Electronic (pdf/doc)
Approved: Gosstandart of Russia,
12/21/2000
SKU: RUSS20352
The Product is Contained in the Following Classifiers:
Construction (Max) »
Standards »
Other state standards used in construction »
29 Electrical Engineering »
ISO classifier »
13 ENVIRONMENTAL PROTECTION, HUMAN PROTECTION AGAINST ENVIRONMENTAL IMPACT. SECURITY »
13.260 Protection against electric shock. Means of protection »
National standards »
13 ENVIRONMENTAL PROTECTION, HUMAN PROTECTION AGAINST ENVIRONMENTAL IMPACT. SECURITY »
13.260 Protection against electric shock. Means of protection »
ISO classifier »
29 ELECTRICAL ENGINEERING »
29.130 Switching and control equipment »
29.130.20 Low-voltage switching equipment and control equipment »
National standards »
29 ELECTRICAL ENGINEERING »
29.130 Switching and control equipment »
29.130.20 Low-voltage switching equipment and control equipment »
ISO classifier »
29 ELECTRICAL ENGINEERING »
29.240 Power transmission networks and distribution networks »
29.240.20 Power lines and distribution lines »
National standards »
29 ELECTRICAL ENGINEERING »
29.240 Power transmission networks and distribution networks »
29.240.20 Power lines and distribution lines »
ISO classifier »
29 ELECTRICAL ENGINEERING »
29.240 Power transmission networks and distribution networks »
29.240.30 Control equipment for electrical power systems »
National standards »
29 ELECTRICAL ENGINEERING »
29.240 Power transmission networks and distribution networks »
29.240.30 Control equipment for electrical power systems »
National Standards for KGS (State Standards Classification) »
Latest edition »
E Power and electrical equipment »
E1 Power plants, substations and distribution devices »
E17 Switchgears »
National Standards for OKSTU »
ELECTRICAL EQUIPMENT AND MATERIALS »
Complete devices for voltages up to 1000 V »
The Document is Replaced With:
GOST R 51321.1-2007: Low-voltage switchgear and control gear assemblies. Part 1. Type-tested and partially type-tested assemblies. General technical requirements and test methods
The Document References:
GOST 14254-96: Degrees of protection provided by enclosures (IP Code)
GOST 15.001-88: System of product development and launching into manufacture. Products of industrial and technical designation
GOST 15150-69: Machines, instruments and other industrial products. Modifications for different climatic regions. Categories, operating, storage and transportation conditions as to environment climatic aspects influence
GOST 15543.1-89: Electrical articles. General requirements for environmental climatic aspects stability
GOST 16357-83: Nonlinear resistor-type arresters for standard ac voltage
GOST 16442-80: Plastics insulated power cables. Specifications
GOST 16504-81: The state system of testing products. Product test and quality inspection. General terms and definitions
GOST 17516.1-90: Electrical articles. General requirement for environment mechanical stability
GOST 2.601-95: Operational documents
GOST 21991-89: Electrotechnical equipment. Standard directions of movement for actuators which control the operation of electrical apparatus
GOST 23216-78: Electrotechnical products. Storage, transportation, temporary corrosion protection and packing. General requirements and test methods
GOST 27.003-90: Reliability in engineering. Make-up and general rules for assigning reliability requirements
GOST 27.410-87: Industrial product dependability. Inspection methods of reliability indices and plans of check tests on reliability
GOST 27473-87: Method for determining the comparative and the proof tracking indices of solid insulating materials under moist conditions
GOST 27483-87: Fire hazard testing. Test methods. Glow-wire test and guidance
GOST 28779-90: Solid electrical insulating materials. Methods of test for the determination of the flammability when exposed to an igniting source
GOST 29149-91: Colours of indicator lights and push-buttons
GOST 29322-92: Standard voltages
GOST 30011.4.1-96: Low-voltage switchgear and control gear. Part 4. Contactors and motor-starters. Section 1. Electromechanical contactors and motor-starters
GOST 30331.2-95: Electrical installations of buildings. Part 3. General characteristics
GOST 30331.3-95: Electrical installations of buildings. Part 4. Protection for safety. Protection against electric shock
GOST 8865-93: Electrical insulation system. Thermal evalution and classification
GOST R 50030.1-2000: Low-voltage switchgear and controlgear. Part 1. General rules and test methods
GOST R 50030.3-99: Low -voltage switchgear and controlgear. Pat 3. Switchers, disconnectors, switch-disconnectors and fure-combination units
GOST R 50462-92: Identification of conductors by colours or numerals
GOST R 50571.10-96: Electrical installations of buildings. Part 5. Selection and erection of electrical equipment. Chapter 54. Earthing arrangements and protective conductors
GOST R 50571.19-2000: Electrical installations of buildings. Part 4. Protection for safety. Chapter 44. Protection against overvoltages. Section 443. Protection against overvoltages of atmospheric origin or due to switching
GOST R 50571.2-94: Electrical installations of buildings. Part 3. General characteristics
GOST R 50571.3-94: Electrical installations of buildings. Part 4. Protection for safety. Protection against elecric shock
GOST R IEC 227-3-94: Polyvinyl chloride insulated cables of rated voltages up to and including 450/750 V. Non-sheathed cables for fixed wiring
GOST R IEC 227-4-94: Polyvinyl chloride insulated cables of rated voltages up to and including 450/750 V. Sheathed cables for fixed wiring
GOST R IEC 245-4-97: Rubber insulated cables of rated voltages up and including 450/750 V. Cords and flexible cables
GOST R IEC 536-94: Classification of electrical and electronic equipment with regard to protection against electric shock
The Document is Referenced By:
GOST 10580-2006: Technological foundry equipment. General specifications
GOST 12.2.009-99: Metal-working machines. General safety requirements
GOST 12.2.116-2004: Three- and four-roller plate-bending machines. Safety requirements
GOST 12.3.019-80: Occupational safety standards system. Electrical tests and measurements. General safety requirements
GOST 1639-93: Non-ferrous metals and alloys scrap and waste. General specifications
GOST 28840-90: Machines for tension, compression and bending tests of materials
GOST 28845-90: Machines for long time strength creep, testing and relaxation of materials. General technical requirements
GOST 30533-97: General purpose adjustable d. c. drive systems. General technical requirements
GOST R 50030.1-2007: Low-voltage switchgear and controlgear. Part 1. General rules
GOST R 51350-99: Safety requirements for electrical equipment for measurement, control, and laboratory use. Part 1. General requirements
GOST R 51628-2000: Distribution boards for dwelling-houses. General specifications
GOST R 52319-2005: Safety requirements for electrical equipment for measurement, control and laboratory use. Part 1. General requirements
GOST R 52796-2007: Empty enclosures for low-voltage switchgear and control gear assemblies. General requirements
GOST R 53477-2009: Food processing machinery. Dough and pastry brakes. Specifications
GOST R EN 848-1-2011: Safety of woodworking machines. One side milling machines. Part 1. Single spindle milling machines with vertical lower arrangement of spindle
GOST R EN 861-2011: Safety of woodworking machines. Surface planning and thickening machines
GOST R EN 940-2009: Safety of woodworking machines. Combined woodworking machines
GOST R IEC 60204-1-2007: Safety of machinery. Electrical equipment of machines and mechanisms. Part 1. General requirements
GOST R IEC 60204-1-99: Safety of machinery. Electrical equipment of machines. Part 1. General requirements
GOST R IEC 60974-1-2004: Arc welding power sources. Safety requirements
GOST R ISO 22734-2-2014: Hydrogen generators using water electrolysis process. Part 2. Residential applications
GOST R ISO 8528-1-2005: Reciprocating internal combustion engine driven alternating current generating sets. Part 1. Application, ratings and performance
GOST R ISO 8528-4-2005: Reciprocating internal combustion engine driven alternating current generating sets. Part 4. Control gear and switchgear
I 1.03-08: Instructions for protective grounding and potential equalization in electrical installations
KPO 02.04.11-2006: Catalog-list of equipment. Complete control, distribution of electrical energy and protection devices for voltage up to 1000 V
M788-1095: Alphanumeric Designations in Electrical and Engineering Design Documentation
|
Customers Who Viewed This Item Also Viewed:
 |
Liquid lubricating and plastic materials. Method of test for lubricating properties on four ball machine
Language: English |
Armour clothes. Classification and general technical requirements
Language: English |
Food products. Methods for detection and quantity determination of coliformes
Language: English |
Natural gas. Methods of calculation of physical properties. Calculation of physical properties on base information on density of standards conditions and nitrogen and carbon dioxide contents
Language: English |
Hotels design
Language: English |
Railroad rails. General specifications
Language: English |
Potassium chloride
Language: English |
Controllers acting without
Language: English |
 |
|
YOUR ORDERING MADE EASY!
RussianGost.com is an industry-leading company with stringent quality control standards and our dedication to precision, reliability and accuracy are some of the reasons why some of the world’s largest companies trust us to provide their national regulatory framework and for translations of critical, challenging, and sensitive information.
Our niche specialty is the localization of national regulatory databases involving: technical norms, standards, and regulations; government laws, codes, and resolutions; as well as RF agency codes, requirements, and Instructions.
We maintain a database of over 220,000 normative documents in English and other languages for the following 12 countries: Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Mongolia, Russia, Tajikistan, Turkmenistan, Ukraine, and Uzbekistan.
Placing Your Order
Please select your chosen document, proceed to the ‘checkout page’ and select the form of payment of your choice. We accept all major credit cards and bank wire transfers. We also accept PayPal and Google Checkout for your convenience. Please contact us for any additional arrangements (Contract agreements, PO, etc.).
Once an order is placed it will be verified and processed within a few hours up to a rare maximum of 24 hours.
For items in stock, the document/web link is e-mailed to you so that you can download and save it for your records.
For items out of stock (third party supply) you will be notified as to which items will require additional time to fulfil. We normally supply such items in less than three days.
Once an order is placed you will receive a receipt/invoice that can be filed for reporting and accounting purposes. This receipt can be easily saved and printed for your records.
Your Order Best Quality and Authenticity Guarantee
Your order is provided in electronic format (usually an Adobe Acrobat or MS Word).
We always guarantee the best quality for all of our products. If for any reason whatsoever you are not satisfied, we can conduct a completely FREE revision and edit of products you have purchased. Additionally we provide FREE regulatory updates if, for instance, the document has a newer version at the date of purchase.
We guarantee authenticity. Each document in English is verified against the original and official version. We only use official regulatory sources to make sure you have the most recent version of the document, all from reliable official sources.
