GOST IEC 62606-2016
ГОСТ IEC 62606-2016
|
|
Arc fault detection devices for household and similar use. General requirements
Устройства защиты бытового и аналогичного назначения при дуговом пробое. Общие требования
Status: Effective - Introduced for the first time. IUS 10-2017
This standard applies to protection devices for arc breakdown detection (UZDP) of household and similar purposes used in AC circuits. This standard applies to devices that simultaneously detect and limit the arc current to prevent a fire hazard, and defines operating criteria for opening the circuit under specified conditions if the arc current exceeds the limits specified in this standard
Настоящий стандарт распространяется на защитные устройства обнаружения дугового пробоя (УЗДП) бытового и аналогичного назначения, применяемые в цепях переменного тока. Настоящий стандарт распространяется на устройства, которые одновременно выполняют обнаружение и ограничение тока дуги для предупреждения опасности пожара, и определяет рабочие критерии размыкания цепи в заданных условиях, если ток дуги превышает предельные значения, указанные в настоящем стандарте
Choose Language:
Format: Electronic (pdf/doc)
Approved: Federal Agency for Technical Regulation and Metrology,
5/23/2017
SKU: RUSS287151
The Product is Contained in the Following Classifiers:
Construction (Max) »
Standards »
Other state standards used in construction »
29 Electrical Engineering »
ISO classifier »
29 ELECTRICAL ENGINEERING »
29.120 Electrical fittings »
29.120.50 Fuses and other protective devices in case of overload »
National standards »
29 ELECTRICAL ENGINEERING »
29.120 Electrical fittings »
29.120.50 Fuses and other protective devices in case of overload »
The Document References:
GOST 14254-96: Degrees of protection provided by enclosures (IP Code)
GOST 27483-87: Fire hazard testing. Test methods. Glow-wire test and guidance
GOST 28216-89: Basic environmental testing procedures. Part 2. Tests. Test Db and guidance: damp heat, cyclic (12 + 12 hour cycle)
GOST 30331.1-2013: Low-voltage electrical installations. Part 1. Fundamental principles, assessment of general characteristics, definitions
GOST 30331.4-95: Electrical installations of buildings. Part 4. Protection for safety. Protection against thermal effects
GOST 30331.5-95: Electrical installations of buildings. Part 4. Protection for safety. Protection against overcurrent
GOST 30331.6-95: Electrical installations of buildings. Part 4. Protection for safety. Protection against undervoltage
GOST 30331.7-95: Electrical installations of buildings. Part 4. Protection for safety. Insulation, switching off, control
GOST 30331.9-95: Electrical installations of buildings. Part 4. Protection for safety. Measures of protection against overcurrent
GOST 31216-2003: Еlectromagnetic compatibility of technical equipment. Residual current-operated protective devices (rcds) for household and similar use. Requirements and test methods
GOST CISPR 14-1-2015: Electromagnetic compatibility. Requirements for household appliances, electric tools and similar apparatus. Part 1. Emission
GOST IEC 61008-1-2012: Residual current operated circuit-breakers without integral overcurrent protection for household and similar uses (RCCB'S). Part 1. General rules
GOST IEC 61009-1-2014: Switches, automatic, triggered by residual current, with built-in protection against overcurrent, household and similar purposes. Part 1. General rules
GOST R 50571.10-96: Electrical installations of buildings. Part 5. Selection and erection of electrical equipment. Chapter 54. Earthing arrangements and protective conductors
GOST R 50571.11-96: Electrical installations of buildings. Part 7. Requirements for special installations or locations. Section 701. Locations containing a bath tub or shower basin
GOST R 50571.12-96: Electrical installations of buildings. Part 7. Requirements for special installations or locations. Section 703. Locations containing sauna heaters
GOST R 50571.13-96: Electrical installations of buidings. Part 7. Requirements for special installations or locations. Section 706. Restrictive conducting locations
GOST R 50571.14-96: Electrical installations of buildings. Part 7. Requirements for special installations or locations. Section 705. Electrical installations of agricultural and stock-breeding buildings
GOST R 50571.15-97: Electrical installations of buildings
GOST R 50571.16-99: Electrical installations of buildings. Part 6. Verification. Chapter 61. Initial verification
GOST R 50571.17-2000: Electrical installations of buildings. Part 4. Protection for safety. Chapter 48. Choice of protective measures as a function of external influences. Section 482. Protection against fire
GOST R 50571.18-2000: Electrical installations of buildings. Part 4. Protection for safety. Chapter 44. Protection against overvoltages. Section 442. Protection of low-voltage installations against faults between high-voltage systems and earth
GOST R 50571.19-2000: Electrical installations of buildings. Part 4. Protection for safety. Chapter 44. Protection against overvoltages. Section 443. Protection against overvoltages of atmospheric origin or due to switching
GOST R 50571.1-93: Electrical installations of buildings. General
GOST R 50571.20-2000: Electrical installations of buildings. Part 4. Protection for safety. Chapter 44. Protection against overvoltages. Section 444. Protection against electromagnetic interferences (EMI) in installations of buildings
GOST R 50571.21-2000: Electrical installations of buildings. Part 5. Selection and erection of electrical equipment. Section 548. Earthing arrangements and equipotential bolding for information technology installations
GOST R 50571.22-2000: Electrical installations of buildings. Part 7. Requirements for special installations or locations. Section 707. Earthling requirements for the installation of data processing equipment
GOST R 50571.23-2000: Electrical installations of buildings. Part 7. Requirements for special installations or locations. Section 704. Construction and demolition site installations
GOST R 50571.24-2000: Electrical installations of buildings. Part 5. Selection and erection of electrical equipment. Chapter 51. Common rules
GOST R 50571.25-2001: Electrical installations of buildings. Part 7. Requirements for special installations. Electrical installations of buildings and structures with electrical heating of floors and surfaces
GOST R 50571.26-2002: Electrical installations of buildings. Part 5. Selection and erection of electrical equipment. Section 534. Devices for protection against surge overvoltages
GOST R 50571.27-2003: Electrical installations of buildings. Part 7-740. Requirements for special installations or locations. Temporary electrical installations for structures, amusement devices and booths at fairgrounds, amusement parks and circuses
GOST R 50571.28-2006: Electrical installations of buildings. Part 7-710. Requirements for special electrical installations. Medical locations
GOST R 50571.2-94: Electrical installations of buildings. Part 3. General characteristics
GOST R 50571.3-94: Electrical installations of buildings. Part 4. Protection for safety. Protection against elecric shock
GOST R 50571.4-94: Electrical installations of buildings. Part 4. Protection for safety. Protection against thermal effects
GOST R 50571.5-94: Electrical installations of buildings. Part 4. Protection for safety. Protection against overcurrent
GOST R 50571.6-94: Electrical installations of buildings. Part 4. Protection for safety. Protection against undervoltage
GOST R 50571.7-94: Electrical installations of buildings. Part 4. Protection for safety. Isolation, switching off, control
GOST R 50571.8-94: Electrical installations of buildings. Part 4. Protection for safety. Application of protective measures for safety. Measures of protection against electric shock
GOST R 50571.9-94: Electrical installations of buildings. Part 4. Security requirements. Application of overcurrent protection measures
Technical regulations of the Customs Union TR TS 004/2011: About the safety of low voltage equipment
The Document is Referenced By:
GOST R 50571.4.42-2017: Low-voltage electrical installations. Part 4-42. Protection for safety. Protection against thermal effects
SP 451.1325800.2019: Public buildings with the use of wooden structures. Design rules
SP 452.1325800.2019: Residential multi-apartment buildings with the use of wooden structures. Design rules
|
Customers Who Viewed This Item Also Viewed:
 |
Industrial process measurement and control equipment. Reliability. General requirements and test methods
Language: English |
Metals. Methods of tension test
Language: English |
Gauged corrosion-resistant, heat-resistant and high-temperature steel shape
Language: English |
Heating, ventilation and air conditioning. Fire Safety Requirements
Language: English |
Reliability of atomic power stations and their equipment. General statements and reliability index nomenclature
Language: English |
Electromagnetic compatibility of technical equipment. Technical equipment for nuclear power plants. Requirement and test methods
Language: English |
Billets made of corrosion-resistant steels of 12Х18Н9Т, 12Х18Н10Т, 08Х18Н10Т, 10Х17Н13М2Т, 12Х18Н12Т and 03Х21Н32М3Б types.
Language: English |
Dependability in technics. Terms and definitions
Language: English |
System of products development and launching into manufacture. Technical assignment. Requirements to contents and form of presentation
Language: English |
Reliability in technology. Composition and general rules for setting reliability requirements
Language: English |
Stainless corrosion resisting, heat-resisting and creep resisting steel and alloy on iron-nickel-based products. Specifications
Language: English |
Natural gas for industrial and municipal purposes. Technical conditions
Language: English |
Global navigation satellite system. Emergency response system in case of accidents. Test methods for emergency services call device/system for compliance with the requirements for the quality of loudspeaker communication in the vehicle cab.
Language: English |
 |
|
YOUR ORDERING MADE EASY!
RussianGost.com is an industry-leading company with stringent quality control standards and our dedication to precision, reliability and accuracy are some of the reasons why some of the world’s largest companies trust us to provide their national regulatory framework and for translations of critical, challenging, and sensitive information.
Our niche specialty is the localization of national regulatory databases involving: technical norms, standards, and regulations; government laws, codes, and resolutions; as well as RF agency codes, requirements, and Instructions.
We maintain a database of over 220,000 normative documents in English and other languages for the following 12 countries: Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Mongolia, Russia, Tajikistan, Turkmenistan, Ukraine, and Uzbekistan.
Placing Your Order
Please select your chosen document, proceed to the ‘checkout page’ and select the form of payment of your choice. We accept all major credit cards and bank wire transfers. We also accept PayPal and Google Checkout for your convenience. Please contact us for any additional arrangements (Contract agreements, PO, etc.).
Once an order is placed it will be verified and processed within a few hours up to a rare maximum of 24 hours.
For items in stock, the document/web link is e-mailed to you so that you can download and save it for your records.
For items out of stock (third party supply) you will be notified as to which items will require additional time to fulfil. We normally supply such items in less than three days.
Once an order is placed you will receive a receipt/invoice that can be filed for reporting and accounting purposes. This receipt can be easily saved and printed for your records.
Your Order Best Quality and Authenticity Guarantee
Your order is provided in electronic format (usually an Adobe Acrobat or MS Word).
We always guarantee the best quality for all of our products. If for any reason whatsoever you are not satisfied, we can conduct a completely FREE revision and edit of products you have purchased. Additionally we provide FREE regulatory updates if, for instance, the document has a newer version at the date of purchase.
We guarantee authenticity. Each document in English is verified against the original and official version. We only use official regulatory sources to make sure you have the most recent version of the document, all from reliable official sources.
