GOST R 8.741-2019
ГОСТ Р 8.741-2019
|
|
State system for ensuring the uniformity of measurements. The volume of natural gas. General requirements for measurement procedures
Государственная система обеспечения единства измерений. Объем природного газа. Общие требования к методикам измерений
Status: Valid - Supersedes
The standard applies to the methods of measuring the volume of natural gas, which corresponds to the quality of the national standard, regional standard, international standard, and in the absence of these standards, to the organization’s standard, and establishes the general requirements for the methods of measuring the volume of gas reduced to standard conditions.
Стандарт распространяется на методики измерений объема природного газа, соответствующего по качеству национальному стандарту, региональному стандарту, международному стандарту, а в случае отсутствия указанных стандартов - стандарту организации, и устанавливает общие требования к методикам измерений объема газа, приведенного к стандартным условиям.
Choose Language:
Format: Electronic (pdf/doc)
Approved: Federal Agency for Technical Regulation and Metrology,
9/12/2019
SKU: RUSS376041
The Product is Contained in the Following Classifiers:
PromExpert »
SECTION II. METROLOGICAL »
II Measurements »
2 Measurement of mechanical quantities »
ISO classifier »
17 METROLOGY AND MEASUREMENTS. PHYSICAL PHENOMENA »
17.020 Metrology and measurements in general »
National standards »
17 METROLOGY AND MEASUREMENTS. PHYSICAL PHENOMENA »
17.020 Metrology and measurements in general »
National Standards for KGS (State Standards Classification) »
Latest edition »
T General technical and organizational and methodological standards »
T8 State measurement system »
T86 Measurement Techniques »
T86.3 Measurement of parameters of flow, consumption, level, volume of substances »
As a Replacement Of:
GOST R 8.741-2011: State system for ensuring the uniformity of measurements. Volume of natural gaz. General requirements for measurement procedure
The Document References:
Federal Law 162-FZ: About standardization in the Russian Federation
GOST 12.0.004-2015: Occupational safety standards system. Organization of training for labor safety. General principles
GOST 15528-86: Instruments for measuring flow rate, volume or mass of flowing fluid and gas. Terms and definitions
GOST 30319.2-2015: Natural gas. Methods of calculation of physical properties. Calculation of physical properties on base information on density of standards conditions and nitrogen and carbon dioxide contents
GOST 30319.3-2015: Natural gas. Methods of calculation of physical properties. Calculation of physical properties on base information on component composition
GOST 31369-2008: Natural gas. Calculation of calorific values, density, relative density and Wobbe index from composition
GOST 31370-2008: Natural gas. Sampling guidelines
GOST 31371.1-2008: Natural gas. Determination of composition with defined uncertainty by gas chromatography method. Part 1. Guidelines for tailored analysis
GOST 31371.2-2008: Natural gas. Determination of composition with defined uncertainty by gas chromatography method. Part 2. Measuring-system characteristics and statistics for processing of data
GOST 31371.3-2008: Natural gas. Determination of composition with defined uncertainty by gas chromatography method. Part 3. Determination of hydrogen, helium, oxygen, nitrogen, carbon dioxide and hydrocarbons up to C8 using two packed columns
GOST 31371.4-2008: Natural gas. Determination of composition with defined uncertainty by gas chromatography method. Part 4. Determination of nitrogen, carbon dioxide and C1 to C5 and C6+ hydrocarbons for a laboratory and on-line measuring system using two columns
GOST 31371.5-2008: Natural gas. Determination of composition with defined uncertainty by gas chromatography method. Part 5. Determination of nitrogen, carbon dioxide and C1 to C5 and C6+ hydrocarbons for a laboratory and on-line process application using three columns
GOST 31371.6-2008: Natural gas. Determination of composition with defined uncertainty by gas chromatography method. Part 6. Determination of hydrogen, helium, oxygen, nitrogen, carbon dioxide and C1 to C8 hydrocarbons using three capillary columns
GOST 31371.7-2008: Natural gas. Determination of composition with defined uncertainty by gas chromatography method. Part 7. Measurement procedure of the mole fraction of components
GOST 34100.3-2017: Uncertainty of measurement. Part 3. Guide to the expression of uncertainty in measurement
GOST 8.586.5-2005: State system for ensuring the uniformity of measurements. Measurements of liquids and gases flow rate and quantity by means of orifice instruments. Part 5. Measurement procedure
GOST R 53762-2009: Natural combustible gases. Determination of hydrocarbon dew point temperature
GOST R 53763-2009: Natural combustible gases. Determination of water dew point temperature
GOST R 8.563-2009: State system for ensuring the uniformity of measurements. Procedures of measurements
GOST R 8.662-2009: State system for ensuring the uniformity of measurements. Natural gas. Gas phase thermodynamic properties. Methods of calculation for transmission and distribution applications on base of the AGA8 fundamental equation of state
GOST R 8.899-2015: State system for ensuring the uniformity of measurements. Measurements of liquids and gases flow rate and quantity by means of orifice instruments. Verification of measurement procedure
MI 1317-2004: State system for ensuring uniformity of measurements. Results and characteristics of the measurement error. Forms of representation. Ways to use during testing of product samples and control over the parameters of product samples and control of their para
MI 2667-2011: Recommendation. State system for ensuring uniformity of measurements. Consumption and quantity of liquids and gases. Measurement techniques using averaging pressure tubes ANNUBAR DIAMOND II, ANNUBAR 285, ANNUBAR 485 and ANNUBAR 585. Basic provisions
MI 3082-2007: State system for ensuring uniformity of measurements. The choice of methods and means of measuring flow and the amount of consumed natural gas, depending on the operating conditions at metering stations Recommendations on the choice of working standards for their calibration
MI 3269-2010: Recommendation. State system for ensuring uniformity of measurements. Construction, presentation, design and content of documents on methods (methods) of measurement
Order 101: Federal norms and rules in the field of industrial safety "Safety rules in the oil and gas industry"
Order 4091: The procedure for attestation of primary reference measurement techniques (methods), reference measurement techniques (methods) and measurement techniques (methods) and their application
Order 542: Federal norms and rules in the field of industrial safety "Safety rules for gas distribution and gas consumption networks"
Order 542: On approval of standard lease agreements for forest areas
PMG 96-2009: State system for ensuring the uniformity of measurements. Results and characteristics of measurement quality
RD 50-453-84: Procedural Guidelines for Error Characteristics of Measuring Devices Under Actual Operating Conditions. Calculation Methods
RMG 29-2013: State system for ensuring the uniformity of measurements. Metrology. Basic terms and definitions
RMG 62-2003: State system for ensuring the uniformity of measurements. Ensuring the effect of measurements by the control of technological processes. Estimation of the measuring error when the limited point of information
|
Customers Who Viewed This Item Also Viewed:
 |
Tight and slack wooden barrels
Language: English |
Cylindrical evolvent gears of external engagment. Strength calculation
Language: English |
Plastics structured-wall pipes and their fittings for sewerage systems outside the buildings. Specifications
Language: English |
Vegetable oils. General technical requirements
Language: English |
Current transformers. General specifications
Language: English |
 |
|
YOUR ORDERING MADE EASY!
RussianGost.com is an industry-leading company with stringent quality control standards and our dedication to precision, reliability and accuracy are some of the reasons why some of the world’s largest companies trust us to provide their national regulatory framework and for translations of critical, challenging, and sensitive information.
Our niche specialty is the localization of national regulatory databases involving: technical norms, standards, and regulations; government laws, codes, and resolutions; as well as RF agency codes, requirements, and Instructions.
We maintain a database of over 220,000 normative documents in English and other languages for the following 12 countries: Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Mongolia, Russia, Tajikistan, Turkmenistan, Ukraine, and Uzbekistan.
Placing Your Order
Please select your chosen document, proceed to the ‘checkout page’ and select the form of payment of your choice. We accept all major credit cards and bank wire transfers. We also accept PayPal and Google Checkout for your convenience. Please contact us for any additional arrangements (Contract agreements, PO, etc.).
Once an order is placed it will be verified and processed within a few hours up to a rare maximum of 24 hours.
For items in stock, the document/web link is e-mailed to you so that you can download and save it for your records.
For items out of stock (third party supply) you will be notified as to which items will require additional time to fulfil. We normally supply such items in less than three days.
Once an order is placed you will receive a receipt/invoice that can be filed for reporting and accounting purposes. This receipt can be easily saved and printed for your records.
Your Order Best Quality and Authenticity Guarantee
Your order is provided in electronic format (usually an Adobe Acrobat or MS Word).
We always guarantee the best quality for all of our products. If for any reason whatsoever you are not satisfied, we can conduct a completely FREE revision and edit of products you have purchased. Additionally we provide FREE regulatory updates if, for instance, the document has a newer version at the date of purchase.
We guarantee authenticity. Each document in English is verified against the original and official version. We only use official regulatory sources to make sure you have the most recent version of the document, all from reliable official sources.
