GOST 35052.1-2021
ГОСТ 35052.1-2021
|
|
Switches for fixed electrical installations for domestic and similar purposes. Part 1. General requirements
Выключатели для стационарных электрических установок бытового и аналогичного назначения. Часть 1. Общие требования
Status: Accepted
This standard applies to installation switches (hereinafter - switches) of general purpose, manually actuated, designed for household and similar stationary electrical installations of only alternating current for rated voltage of not more than 440 V and rated current of not more than 63 A when installed indoors and outdoors. For switches with screwless terminals, the rated current is limited to 16 A. The switches described in this standard are designed to control, under normal operation, all of the following loads: - a tungsten incandescent lamp load circuit; - a lamp load circuit with external ballast (e.g., LED (light emitting diode lamp), CFL (compact fluorescent lamp), fluorescent lamp load); - a lamp load circuit with integral ballast (e.g., LEDi or CFLi); - circuits for mainly active loads with a power factor of at least 0.95; - a single-phase circuit for motor loads with a rated current of not more than 3 A at 250 V (750 VA) and 4.5 A at 120 V (540 VA) and a power factor of at least 0.6. This applies to both circuit breakers with a rating of not less than 10 A that have not been further tested and self-resetting circuit breakers with a rating of not less than 6 A that have not been further tested. This standard applies to circuit breaker boxes, with the exception of mounting boxes for flush-type circuit breakers
Настоящий стандарт распространяется на установочные выключатели (далее — выключатели) общего назначения, приводимые в действие вручную, предназначенные для бытовых и аналогичных стационарных электрических установок только переменного тока на номинальное напряжение не более 440 В и номинальный ток не более 63 А при установке внутри и вне помещений.
Для выключателей с безвинтовыми зажимами номинальный ток ограничивается значением 16 А.
Выключатели, описанные в настоящем стандарте, предназначены для управления при нормальной эксплуатации всех следующих нагрузок:
- цепь для нагрузки вольфрамовой лампы накаливания;
- цепь для нагрузки ламп с внешним балластом (например, LED (лампа со светоизлучающими диодами), CFL (компактная люминесцентная лампа), нагрузка на люминесцентную лампу);
- цепь для нагрузки ламп со встроенным балластом (например, LEDi или CFLi);
- цепями в основном активной нагрузки с коэффициентом мощности не менее 0,95;
- однофазная цепь для нагрузки электродвигателя с номинальным током не более 3 А при 250 В (750 ВА) и 4,5 А при 120 В (540 ВА) и коэффициенте мощности не менее 0,6. Это относится как к выключателям с номиналом не менее 10 А, которые не прошли дополнительные испытания, так и к выключателям с самовозвратом с номиналом не менее 6 А, которые не прошли дополнительные испытания.
Настоящий стандарт применяется к коробкам для выключателей, за исключением монтажных коробок для выключателей скрытого типа
Choose Language:
Format: Electronic (pdf/doc)
SKU: RUSS443832
The Product is Contained in the Following Classifiers:
ISO classifier »
29 ELECTRICAL ENGINEERING »
29.120 Electrical fittings »
29.120.40 Switches »
National standards »
29 ELECTRICAL ENGINEERING »
29.120 Electrical fittings »
29.120.40 Switches »
The Document References:
GOST 14254-2015: Degrees of protection provided by enclosures (IP Code)
GOST 22483-2021: Conductive conductors for cables, wires and cords
GOST 29322-2014: Standard voltages
GOST 30630.1.10-2013: Test methods for resistance to mechanical external influencing factors for machines, instruments and other industrial products. Strikes on casing of device
GOST 31602.1-2012: Connecting devices. Electrical copper conductors. Safety requirements for screw-type and screwless-type clamping units. Part 1. General requirements and particular requirements for clamping units for conductors from 0,2 up to 35 sq. mm (included)
GOST 31602.2-2012: Connecting devices. Safety requirements for screw-type and screwless-type clamping units for electrical copper coductors. Part 2. Particular reqirements for conductors from 35 up to 300 kv. mm
GOST 31604-2020: Connecting devices. Devices for connecting aluminum conductors to clamps of any material and copper conductors to clamps from aluminum alloys. General requirements and test methods
GOST IEC 60050-151-2014: International electrotechnical vocabulary. Part 151. Electrical and magnetic devices
GOST IEC 60050-441-2015: International Electrotechnical Vocabulary. Chapter 441. Switchgear, controlgear and fuses
GOST IEC 60050-442-2015: International Electrotechnical Vocabulary. Part 442. Electrical accessories
GOST IEC 60050-581-2015: International Electrotechnical Vocabulary. Part 581. Electromechanical components for electronic equipment
GOST IEC 60227-1-2011: Polyvinyl chloride insulated cables of rated voltages up to and including 450/750 V. Part 1. General requirements
GOST IEC 60227-2-2012: Polyvinylchloride insulated cables of rated voltages up to and including 450/750V. Part 2. Test methods
GOST IEC 60227-3-2011: Polyvinyl chloride insulated cables of rated voltages up to and including 450/750 V. Non-sheathed cables for fixed wiring
GOST IEC 60227-4-2011: Polyvinyl chloride insulated cables of rated voltages up to and including 450/750 V. Sheathed cables for fixed wiring
GOST IEC 60227-5-2013: Cables with polyvinylchloride resin insulation at a nominal voltage up to 450/750 V including. Part 5 Flexible cables (cords).
GOST IEC 60227-6-2011: Polyvinyl chloride insulated cables of rated voltages up to and including 450/750 V. Lift cables and cables for flexible connections
GOST IEC 60227-7-2012: Polyvinylchloride insulated cables of rated voltages up to and including 450/750V. Part 7. Flexible cables screened and unscreened with two or more conductors
GOST IEC 60245-1-2011: Rubber insulated cables for rated voltages up to and including 450/750 V. Part 1. General requirements
GOST IEC 60245-2-2011: Rubber insulated cables of rated voltages up to and including 450/750 V. Test methods
GOST IEC 60245-3-2011: Rubber insulated cables of rated voltages to 450/750 V including. Heat resistant silicone insulated cables
GOST IEC 60245-4-2011: Rubber insulated cables for rated voltages up to and including 450/750 V. Part 4. Cords and flexible cables
GOST IEC 60245-5-2011: Rubber insulated cables of rated voltages to 450/750 V including. Lift cables
GOST IEC 60245-6-2011: Rubber insulated cables of rated voltages up to and including 450/750 V. Arc welding electrode cables
GOST IEC 60245-7-2011: Rubber insulated cables of rated voltages to 450/750 v including. Heat-resistant ethylene-vinyl acetate rubber insulated cables
GOST IEC 60245-8-2011: Rubber insulated cables for rated voltages up to and including 450/750 V. Part 8. Cords for applications requiring high flexibility
GOST IEC 60669-2-4-2017: Switches for household and similar fixed electrical installations. Part 2-4. Particular requirements. Isolating switches
GOST IEC 60669-2-5-2017: Switches for household and similar fixed electrical installations. Part 2-5. Particular requirements. Switches and related accessories for use in home and building electronic systems
GOST IEC 60669-2-6-2015: Switches for household and similar stationary electrical installations. Part 2-6. Additional requirements for emergency switches for external and internal lighting
GOST IEC 60670-1-2016: Boxes and enclosures for electrical accessories for household and similar fixed electrical installations. Part 1. General requirements
GOST IEC 60695-2-11-2013: Fire hazard testing. Part 2-11. Glowing/hot-wire based test methods. Glow-wire flammability test method for end-products
GOST IEC 60998-1-2017: Connecting devices for low-voltage circuits for household and similar purposes. Part 1. General requirements
GOST IEC 60998-2-1-2013: Connecting devises for low-voltage circuit for household and similar purposes. Part 2-1. Particular requirements for connecting devices as separate entities with screw-type clamping units
GOST IEC 60998-2-2-2013: Connecting devises for low-voltage circuit for household and similar purposes. Part 2-2. Particular requirements for connecting devices as separate entities with screwless-type clamping units
GOST IEC 60998-2-3-2017: Connecting devices for low-voltage circuits for household and similar purposes. Part 2-3. Additional requirements for contact clamps piercing the insulation of copper conductors to connect them
GOST IEC 60998-2-4-2013: Connecting devises for low-voltage circuit for household and similar purposes. Part 2-4. Particular requirements for twist-on connecting devices
GOST IEC 61347-1-2019: Control gear for lamps. Part 1. General and safety requirements
GOST ISO 2081-2017: Metallic and other inorganic coatings. Electroplated coatings of zinc with supplementary treatments on iron and steel
GOST R 51324.2.1-2012: Switches for household and similar fixed electrical installations. Part 2-1. Particular requirements. Electronic switches
GOST R 51324.2.2-2012: Switches for household and similar fixed electrical installations. Part 2-2. Particular requirements for remote-control switches (RCS)
GOST R 51324.2.3-2012: Switches for household and similar fixed electrical installations. Part 2-3. Particular requirements for time-delay switches (TDS)
GOST R IEC 60695-2-10-2011: Fire hazard testing. Part 2-10. Glowing/hot-wire based test methods. Glow-wire apparatus and common test procedures
GOST R IEC 61032-2000: Protection of persons and equipment by enclosures. Probes for verification
GOST R IEC 61347-1-2011: Lamp control gear. Part 1. General and safety requirements
|
Customers Who Viewed This Item Also Viewed:
 |
Industrial process measurement and control equipment. Reliability. General requirements and test methods
Language: English |
Metals. Methods of tension test
Language: English |
Gauged corrosion-resistant, heat-resistant and high-temperature steel shape
Language: English |
Heating, ventilation and air conditioning. Fire Safety Requirements
Language: English |
Reliability of atomic power stations and their equipment. General statements and reliability index nomenclature
Language: English |
Electromagnetic compatibility of technical equipment. Technical equipment for nuclear power plants. Requirement and test methods
Language: English |
Billets made of corrosion-resistant steels of 12Х18Н9Т, 12Х18Н10Т, 08Х18Н10Т, 10Х17Н13М2Т, 12Х18Н12Т and 03Х21Н32М3Б types.
Language: English |
Dependability in technics. Terms and definitions
Language: English |
System of products development and launching into manufacture. Technical assignment. Requirements to contents and form of presentation
Language: English |
Reliability in technology. Composition and general rules for setting reliability requirements
Language: English |
Stainless corrosion resisting, heat-resisting and creep resisting steel and alloy on iron-nickel-based products. Specifications
Language: English |
Natural gas for industrial and municipal purposes. Technical conditions
Language: English |
Global navigation satellite system. Emergency response system in case of accidents. Test methods for emergency services call device/system for compliance with the requirements for the quality of loudspeaker communication in the vehicle cab.
Language: English |
 |
|
YOUR ORDERING MADE EASY!
RussianGost.com is an industry-leading company with stringent quality control standards and our dedication to precision, reliability and accuracy are some of the reasons why some of the world’s largest companies trust us to provide their national regulatory framework and for translations of critical, challenging, and sensitive information.
Our niche specialty is the localization of national regulatory databases involving: technical norms, standards, and regulations; government laws, codes, and resolutions; as well as RF agency codes, requirements, and Instructions.
We maintain a database of over 220,000 normative documents in English and other languages for the following 12 countries: Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Mongolia, Russia, Tajikistan, Turkmenistan, Ukraine, and Uzbekistan.
Placing Your Order
Please select your chosen document, proceed to the ‘checkout page’ and select the form of payment of your choice. We accept all major credit cards and bank wire transfers. We also accept PayPal and Google Checkout for your convenience. Please contact us for any additional arrangements (Contract agreements, PO, etc.).
Once an order is placed it will be verified and processed within a few hours up to a rare maximum of 24 hours.
For items in stock, the document/web link is e-mailed to you so that you can download and save it for your records.
For items out of stock (third party supply) you will be notified as to which items will require additional time to fulfil. We normally supply such items in less than three days.
Once an order is placed you will receive a receipt/invoice that can be filed for reporting and accounting purposes. This receipt can be easily saved and printed for your records.
Your Order Best Quality and Authenticity Guarantee
Your order is provided in electronic format (usually an Adobe Acrobat or MS Word).
We always guarantee the best quality for all of our products. If for any reason whatsoever you are not satisfied, we can conduct a completely FREE revision and edit of products you have purchased. Additionally we provide FREE regulatory updates if, for instance, the document has a newer version at the date of purchase.
We guarantee authenticity. Each document in English is verified against the original and official version. We only use official regulatory sources to make sure you have the most recent version of the document, all from reliable official sources.
