GOST R 12.4.246-2008
ГОСТ Р 12.4.246-2008
|
|
Occupational safety standards system. Personal protective means of hands. Gloves. General technical requirements. Test methods
Система стандартов безопасности труда. Средства индивидуальной защиты рук. Перчатки. Общие технические требования. Методы испытаний
Status: Not effective - Canceled. Information on the registration of 1160-st dated 10/15/2013 (the official website of Rosstandart); (IUS 2-2014)
This standard applies to personal protective equipment used to protect them from the harmful effects of various external factors: - sewing (made from fabrics of various raw materials, artificial and natural leather, knitted and non-woven fabrics); - knitted; - welded; - dipped, shtavanny (latex and polymeric materials, film and textile based). This standard establishes general technical requirements for them and test methods for finished products in general.
Настоящий стандарт распространяется на средства индивидуальной защиты рук, применяемые для их защиты от вредного воздействия различных внешних факторов: - швейные (изготовленные из тканей различного сырьевого состава, искусственных и натуральных кож, трикотажных и нетканых полотен); - вязаные; - сварные; - маканые, штанцованные (латексные и из полимерных материалов, пленочные и на текстильной основе). Настоящий стандарт устанавливает общие технические требования к ним и методы испытаний готовых изделий в целом
Choose Language:
Format: Electronic (pdf/doc)
Approved: Federal Agency for Technical Regulation and Metrology,
12/18/2008
SKU: RUSS62822
The Product is Contained in the Following Classifiers:
Construction (Max) »
Standards »
Other state standards used in construction »
13 Environmental protection, protection of people from environmental exposure. Security »
Construction (Max) »
Standards »
Other state standards used in construction »
83 Rubber, technical rubber, asbestos and plastic industries »
Evidence base (TR CU, Technical Regulation of the Customs Union) »
019/2011 TR CU. On safety of personal protective equipment »
Regulations and standards (to ТР ТС 019/2011) »
PromExpert »
SECTION III. LABOR PROTECTION AND SAFETY »
II Industrial sanitation and occupational health »
8 Personal protective equipment »
8.4 Legs, hands protection »
ISO classifier »
13 ENVIRONMENTAL PROTECTION, HUMAN PROTECTION AGAINST ENVIRONMENTAL IMPACT. SECURITY »
13.340 Protective equipment »
13.340.40 Hand protection »
National standards »
13 ENVIRONMENTAL PROTECTION, HUMAN PROTECTION AGAINST ENVIRONMENTAL IMPACT. SECURITY »
13.340 Protective equipment »
13.340.40 Hand protection »
ISO classifier »
83 RUBBER, RUBBER-TECHNICAL, ASBESTOTECHNICAL AND PLASTIC INDUSTRY »
83.140 Rubber and plastic products »
83.140.99 Other rubber and plastic products »
National standards »
83 RUBBER, RUBBER-TECHNICAL, ASBESTOTECHNICAL AND PLASTIC INDUSTRY »
83.140 Rubber and plastic products »
83.140.99 Other rubber and plastic products »
National Standards for KGS (State Standards Classification) »
Latest edition »
T General technical and organizational and methodological standards »
T5 Documentation System »
T58 System of standards infield of nature conservation and improvement of use of natural resources, labor safety, scientific organization of labor »
The Document References:
Federal Law 184-FZ: About technical regulation
GOST 10581-91: Ready-made sewing. Marking, packing, transportation and storage
GOST 11209-85: Cotton and blended fabrics for protective clothing
GOST 12.4.002-97: Vibration protection means for hands
GOST 12.4.063-79: Occupational safety standards system. Means of hands protection. Method for determination of acid and alkali penetrability
GOST 12.4.103-83: Occupational safety standards system. Special protective clothes, personal means of hand and legs protections. Classification
GOST 12.4.115-82: Occupational safety standards system. Personal safety means. General requirements for marking
GOST 12.4.141-99: Occupational safety standards system. Hand protection means, industrial clothing and materials for their manufacture. Methods for determination of cut resistance
GOST 12.4.167-85: Occupational safety standards system. Filmy polymeric materials for hand protection means. Method of determination of abrasion resistance
GOST 12.4.183-91: Materials for means of hand protection
GOST 12.4.184-97: Occupational safety standards system. Fabrics and materials for industrial clothing, hand protection means and upper for safety shoes. Methods for determination of burning-through resistance
GOST 12.4.217-2001: Occupational safety standards system. Personal protection equipment against radioactive substances and ionizing radiation. Requirements and test methods
GOST 12023-2003: Textile materials and articles of them. Method of thickness determination
GOST 12739-85: Knitted fabrics and garments. Method for the determination of abrasion resistance
GOST 13344-79: Waterproof abrasive cloth. Specifications
GOST 19712-89: Knitted garments. Methods for determination of breaking factors and extensibility when loading is less than breaking
GOST 20010-93: Industrial rubber gloves
GOST 270-75: Rubber. Method of the determination elastic and tensile stress-strain properties
GOST 28073-89: Sewing articles. Methods for the determination of breaking load, elongation of thread seams, slippage of fibre trends in seams
GOST 29122-91: Means of individual protection х
GOST 7502-98: Measuring metal tapes. Specifications
GOST 8846-87: Knitted fabrics and garments. Methods for determination of linear dimensions, distortion number of courses and wales and yarn length in the loop
GOST R 1.0-2004: Standardization in the Russian Federation. Basic provisions
SO 153-34.03.603-2003: Guidelines for Use and Testing of Protective Means Used in Electrical Installations
The Document is Referenced By:
GOST R 55030-2012: Public roads and highways. Geosynthetic for road construction. Test method for tensile strength
GOST R 55031-2012: Public roads and highways. Geosynthetic for road construction. Test method for determination of stability to ultra-violet radiation
GOST R 55032-2012: Public roads and highways. Geosynthetic for road construction. Test method for determination of repeated freeze-thaw stability
GOST R 55033-2012: Public roads and highways. Geosynthetic for road construction. Test method for determination of flexibility at low temperature
GOST R 55034-2012: Public roads and highways. Geosynthetic for reinforcement of asphalt layers of road pavement. Test method for determination of heat resistance
GOST R 55035-2012: Public roads and highways. Geosynthetic for road construction. Test method for determining of resistance to aggressive media
GOST R 55398-2013: Reinforced bitumen sheets for waterproofing of bridge decks. Method for determination of thickness and mass per unit area
GOST R 55399-2013: Reinforced bitumen sheets for waterproofing of bridge decks. Method of determination of water absorption
GOST R 55400-2013: Reinforced bitumen sheets for waterproofing of bridge decks. Method for determination of flexibility at low temperatures
GOST R 55401-2013: Reinforced bitumen sheets for waterproofing of bridge decks. Method for determination of dimensional stability
GOST R 55402-2013: Reinforced bitumen sheets for waterproofing of bridge decks. Method of determination of bond strength
GOST R 55403-2013: Reinforced bitumen sheets for waterproofing of bridge decks. Method for determination of shear strength
GOST R 55404-2013: Reinforced bitumen sheets for waterproofing of bridge decks. Method for determining the effect of heat stress on characteristics of material
GOST R 55405-2013: Reinforced bitumen sheets for waterproofing of bridge decks. Method for determination of resistance to water pressure after damage by pre-treatment
GOST R 55406-2013: Reinforced bitumen sheets for waterproofing of bridge decks. Method for determination of visible defects
GOST R 55407-2013: Reinforced bitumen sheets for waterproofing of bridge decks. Method for determination of length, width and straightness
GOST R 55408-2013: Reinforced bitumen sheets for waterproofing of bridge decks. Method of determination of tensile properties
GOST R 55409-2013: Reinforced bitumen sheets for waterproofing of bridge decks. Test method for determination of heat resistance
GOST R 55420-2013: General use highways. Cationic road bitumen emulsions. Specifications
GOST R 55421-2013: General use highways. Emulsion bitumen road cationic. Method for determination of apparent viscosity
GOST R 55422-2013: General use highways. Cationic road bituminous emulsions. Method for determination of the rate of decay
GOST R 55423-2013: General use highways. Cationic road bituminous emulsions. Method for determination of settling tendency
GOST R 55424-2013: General use highways. Cationic road bituminous emulsion. Method for determination of storage stability by sieving
GOST R 55425-2013: General use highways. Cationic road bituminous emulsions. Method of bitumen recovery by evaporation
GOST R 55426-2013: General use highways. Cationic road bituminous emulsions. Method for determination of adhesivity with mineral materials
GOST R 55427-2013: General use highways. Cationic road bituminous emulsions. Method for determination of binder with emulsifying agent content
GOST R 55428-2013: General use highways. Cationic road bituminous emulsions. Method for determination of residue on sieve № 014
GOST R 55475-2013: Dewaxed winter and arctic diesel fuel. Specifications
GOST R 56335-2015: Automobile roads of general use. Public roads and highways. Geosynthetic for road construction. Static puncture test
GOST R 56336-2015: Automobile roads of general use. Geosynthetics. Index test procedure for evaluation of resistance to repeated loading
GOST R 56337-2015: Automobile roads of general use. Geosynthetics. Test procedure for determination of durability at the dynamic forcing through (cone drop test)
GOST R EN 340-2010: Occupational safety standards system. Protective clothing. General technical requirements
GOST R EN 388-2009: Occupational safety standards system. Personal protective means of hands. Protective gloves against mechanical risks. Technical requirements. Test methods
GOST R EN 511-2010: Occupational safety standards system. Personal protective means of hands. Protective gloves against cold. General technical requirements. Test methods
Order 4414: The list of documents in the field of standardization, the application of which on a voluntary basis to ensure compliance with the requirements of technical regulations "On Personal Protective Equipment Safety" approved by Decree of the Government of the Russian Federation on December 24, 2009 № 1213
PNST 10-2012: Automobile roads of general use. Viscous petroleum road bitumens. Determination of the paraffin wax content
PNST 11-2012: Automobile roads of general use. Viscous petroleum road bitumens. Method of determination of kinematic viscosity
PNST 136-2016: Automobile roads of general use. Hot asphalt mixtures and asphalt. The method of determining the tensile strength and stiffness
PNST 2-2012: Automobile roads of general use. Viscous petroleum road bitumens. Determination of the tensile properties of modified bitumen by the force ductility method
PNST 3-2012: Automobile roads of general use. Viscous petroleum road bitumens. Determination of needle penetration
PNST 4-2012: Automobile roads of general use. Viscous petroleum road bitumens. Determination of the softening point. Ring and Ball method
PNST 5-2012: Automobile roads of general use. Viscous petroleum road bitumens. Determination of the Fraass breaking point
PNST 6-2012: Automobile roads of general use. Viscous petroleum road bitumens. Test method determination of dynamic viscosity by rotational viscometer
PNST 7-2012: Automobile roads of general use. Viscous petroleum road bitumens. Determination of flash points. Cleveland open cup method
PNST 8-2012: Automobile roads of general use. Viscous petroleum road bitumens. Determination of the resistance to hardening under influence of heat and air (RTFOT method)
PNST 9-2012: Automobile roads of general use. Viscous petroleum road bitumens. Determination of solubility
Customers Who Viewed This Item Also Viewed:
|
Limit dimension deviation from 0,1 to 10000 mm and surface shape and arrangement allowances, not specified on drawings.
Language: English |
Vessels and apparatus. Norms and methods of strength calculation. General requirements
Language: English |
Norms of structural design of nuclear power plants with reactors of different types
Language: English |
Mineral fertilizers. Method for determination of dynamic strength and attrition
Language: English |
Diesel fuel EURO. Specifications
Language: English |
Inch thread with a profile angle of 55 degrees
Language: English |
|
|
YOUR ORDERING MADE EASY!
RussianGost.com is an industry-leading company with stringent quality control standards and our dedication to precision, reliability and accuracy are some of the reasons why some of the world’s largest companies trust us to provide their national regulatory framework and for translations of critical, challenging, and sensitive information.
Our niche specialty is the localization of national regulatory databases involving: technical norms, standards, and regulations; government laws, codes, and resolutions; as well as RF agency codes, requirements, and Instructions.
We maintain a database of over 220,000 normative documents in English and other languages for the following 12 countries: Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Mongolia, Russia, Tajikistan, Turkmenistan, Ukraine, and Uzbekistan.
Placing Your Order
Please select your chosen document, proceed to the ‘checkout page’ and select the form of payment of your choice. We accept all major credit cards and bank wire transfers. We also accept PayPal and Google Checkout for your convenience. Please contact us for any additional arrangements (Contract agreements, PO, etc.).
Once an order is placed it will be verified and processed within a few hours up to a rare maximum of 24 hours.
For items in stock, the document/web link is e-mailed to you so that you can download and save it for your records.
For items out of stock (third party supply) you will be notified as to which items will require additional time to fulfil. We normally supply such items in less than three days.
Once an order is placed you will receive a receipt/invoice that can be filed for reporting and accounting purposes. This receipt can be easily saved and printed for your records.
Your Order Best Quality and Authenticity Guarantee
Your order is provided in electronic format (usually an Adobe Acrobat or MS Word).
We always guarantee the best quality for all of our products. If for any reason whatsoever you are not satisfied, we can conduct a completely FREE revision and edit of products you have purchased. Additionally we provide FREE regulatory updates if, for instance, the document has a newer version at the date of purchase.
We guarantee authenticity. Each document in English is verified against the original and official version. We only use official regulatory sources to make sure you have the most recent version of the document, all from reliable official sources.