GOST R 50571.18-2000
ГОСТ Р 50571.18-2000
|
|
Electrical installations of buildings. Part 4. Protection for safety. Chapter 44. Protection against overvoltages. Section 442. Protection of low-voltage installations against faults between high-voltage systems and earth
Электроустановки зданий. Часть 4. Требования по обеспечению безопасности. Глава 44. Защита от перенапряжений. Раздел 442. Защита электроустановок до 1 кВ от перенапряжений, вызванных замыканиями на землю в электроустановках выше 1 кВ
Status: Not effective - Superseded. IUS 4-2012
This standard applies to electrical installations of buildings used in all sectors of the country's economy, regardless of their ownership and forms of ownership, and establishes electrical safety requirements by protecting against overvoltage that may occur in electrical installations up to 1 kV due to earth faults in electrical installations 1 kV. In this case, electrical installations up to and above 1 kV can be both electrically connected and not connected to each other.
Настоящий стандарт распространяется на электроустановки зданий, применяемые во всех отраслях экономики страны, независимо от их принадлежности и форм собственности, и устанавливает требования по обеспечению электробезопасности путем защиты от пренапряжений, которые могут возникнуть в электроустановках до 1 кВ из-за замыканий на землю в электроустановках выше 1 кВ. При этом электроустановки до и выше 1 кВ могут быть как электрически связанными, так и не связанными между собой
Choose Language:
Format: Electronic (pdf/doc)
Approved: Gosstandart of Russia,
12/18/2000
SKU: RUSS68269
The Product is Contained in the Following Classifiers:
Construction (Max) »
Standards »
Other state standards used in construction »
29 Electrical Engineering »
Construction (Max) »
Standards »
Other state standards used in construction »
91 Building materials and construction »
PromExpert »
SECTION III. LABOR PROTECTION AND SAFETY »
III Occupational safety requirements for production equipment and processes »
2 Safety requirements for certain types of work »
2.10 Operation of electrical installations, electrical equipment and power tools »
PromExpert »
SECTION III. LABOR PROTECTION AND SAFETY »
II Industrial sanitation and occupational health »
6 Protection against electromagnetic radiation »
6.1 Non-ionizing electromagnetic fields and radiation »
ISO classifier »
29 ELECTRICAL ENGINEERING »
29.120 Electrical fittings »
29.120.50 Fuses and other protective devices in case of overload »
National standards »
29 ELECTRICAL ENGINEERING »
29.120 Electrical fittings »
29.120.50 Fuses and other protective devices in case of overload »
ISO classifier »
91 CONSTRUCTION MATERIALS AND CONSTRUCTION »
91.140 Installations in buildings »
91.140.50 Power supply systems »
National standards »
91 CONSTRUCTION MATERIALS AND CONSTRUCTION »
91.140 Installations in buildings »
91.140.50 Power supply systems »
National Standards for KGS (State Standards Classification) »
Latest edition »
E Power and electrical equipment »
E0 General rules and regulations for electrical and heat engineering »
E07 Occupational Safety »
National Standards for KGS (State Standards Classification) »
Latest edition »
E Power and electrical equipment »
E0 General rules and regulations for electrical and heat engineering »
E08 Application and operation »
National Standards for OKSTU »
ELECTRICAL EQUIPMENT AND MATERIALS »
General rules and regulations »
National Standards for OKSTU »
ELECTRICAL EQUIPMENT AND MATERIALS »
Rules for acceptance, use, operation and repair. Safety engineering »
The Document is Replaced With:
GOST R 50571-4-44-2011: Low-voltage electrical installations. Part 4-44. Safety requirements. Protection against voltage disturbances and electromagnetic disturbances
The Document References:
GOST 30331.1-95: Electrical installations of buildings. General
GOST 30331.2-95: Electrical installations of buildings. Part 3. General characteristics
GOST 30331.3-95: Electrical installations of buildings. Part 4. Protection for safety. Protection against electric shock
GOST 30331.4-95: Electrical installations of buildings. Part 4. Protection for safety. Protection against thermal effects
GOST R 50571.14-96: Electrical installations of buildings. Part 7. Requirements for special installations or locations. Section 705. Electrical installations of agricultural and stock-breeding buildings
GOST R 50571.1-93: Electrical installations of buildings. General
GOST R 50571.2-94: Electrical installations of buildings. Part 3. General characteristics
GOST R 50571.3-94: Electrical installations of buildings. Part 4. Protection for safety. Protection against elecric shock
GOST R 50571.4-94: Electrical installations of buildings. Part 4. Protection for safety. Protection against thermal effects
The Document is Referenced By:
GOST IEC 62606-2016: Arc fault detection devices for household and similar use. General requirements
GOST R 50571.16-2007: Low-voltage electrical installations. Part 6. Tests
GOST R 50571.19-2000: Electrical installations of buildings. Part 4. Protection for safety. Chapter 44. Protection against overvoltages. Section 443. Protection against overvoltages of atmospheric origin or due to switching
GOST R 50571.24-2000: Electrical installations of buildings. Part 5. Selection and erection of electrical equipment. Chapter 51. Common rules
GOST R 50571.26-2002: Electrical installations of buildings. Part 5. Selection and erection of electrical equipment. Section 534. Devices for protection against surge overvoltages
GOST R 50571.29-2009: Electrical installations of buildings. Part 5-55. Selection and erection of electrical equipment. Other equipment
GOST R 50571-4-44-2011: Low-voltage electrical installations. Part 4-44. Safety requirements. Protection against voltage disturbances and electromagnetic disturbances
GOST R 52319-2005: Safety requirements for electrical equipment for measurement, control and laboratory use. Part 1. General requirements
GOST R IEC 60950-22-2009: Information technology equipment. Safety. Part 22. Equipment to be installed outdoors
Manual: Manual for impulse and low consumption fire extinguishing systems
SP 31-110-2003: Design and installation of electrical facilities of residential and public buildings. To replace VSN 59-88
TR 205-09: Technical recommendations on the design of anti-terrorism security systems and integrated security of high-rise and unique buildings
|
Customers Who Viewed This Item Also Viewed:
 |
Liquids for aircrafts systems. Method for determination thermo oxidizing stability and corrosion activity
Language: English |
Plastics structured-wall pipes and their fittings for sewerage systems outside the buildings. Specifications
Language: English |
 |
|
YOUR ORDERING MADE EASY!
RussianGost.com is an industry-leading company with stringent quality control standards and our dedication to precision, reliability and accuracy are some of the reasons why some of the world’s largest companies trust us to provide their national regulatory framework and for translations of critical, challenging, and sensitive information.
Our niche specialty is the localization of national regulatory databases involving: technical norms, standards, and regulations; government laws, codes, and resolutions; as well as RF agency codes, requirements, and Instructions.
We maintain a database of over 220,000 normative documents in English and other languages for the following 12 countries: Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Mongolia, Russia, Tajikistan, Turkmenistan, Ukraine, and Uzbekistan.
Placing Your Order
Please select your chosen document, proceed to the ‘checkout page’ and select the form of payment of your choice. We accept all major credit cards and bank wire transfers. We also accept PayPal and Google Checkout for your convenience. Please contact us for any additional arrangements (Contract agreements, PO, etc.).
Once an order is placed it will be verified and processed within a few hours up to a rare maximum of 24 hours.
For items in stock, the document/web link is e-mailed to you so that you can download and save it for your records.
For items out of stock (third party supply) you will be notified as to which items will require additional time to fulfil. We normally supply such items in less than three days.
Once an order is placed you will receive a receipt/invoice that can be filed for reporting and accounting purposes. This receipt can be easily saved and printed for your records.
Your Order Best Quality and Authenticity Guarantee
Your order is provided in electronic format (usually an Adobe Acrobat or MS Word).
We always guarantee the best quality for all of our products. If for any reason whatsoever you are not satisfied, we can conduct a completely FREE revision and edit of products you have purchased. Additionally we provide FREE regulatory updates if, for instance, the document has a newer version at the date of purchase.
We guarantee authenticity. Each document in English is verified against the original and official version. We only use official regulatory sources to make sure you have the most recent version of the document, all from reliable official sources.
