GOST 8.216-2011
ГОСТ 8.216-2011
|
|
State system for ensuring the uniformity of measurement. Potential transformers Checking methods.
Государственная система обеспечения единства измерений. Трансформаторы напряжения. Методика поверки
Status: Effective - Supersedes. IUS 10-2012
The standard applies to low power transformers: single-phase electronic power supplies for voltages up to 1000 V # A; pulse signal for voltage up to 220 V; matching signal continuous signals of low frequency power up to 25 W; The inductance filter rectifier inductors are up to 80 H and the bias current is up to 100 A and establishes the measurement methods for: insulation resistance; electrical strength of insulation; no-load current and voltage; transformation ratio; voltage asymmetry of windings; overheating temperature; inductance; nonlinear distortion factor; amplitude-frequency distortion coefficient; voltage of the secondary windings in the rated load mode; electrical strength inter-turn and interlayer insulation; good quality.
Стандарт распространяется на трансформаторы напряжения по ГОСТ 23625 и ГОСТ 1983 и устанавливает методику их первичной и периодической поверок. Стандарт распространяется на заземляемые и незаземляемые однофазные и трехфазные электромагнитные, емкостные и электронные (с аналоговым выходом) измерительные (трансформаторы для измерения и трансформаторы для защиты) трансформаторы. Стандарт не распротсраняется на трансформаторы, применяемые в диапазоне свыше 120% от номинального значения напряжения.
Choose Language:
Format: Electronic (pdf/doc)
Approved: Federal Agency for Technical Regulation and Metrology,
12/13/2011
SKU: RUSS70078
The Product is Contained in the Following Classifiers:
PromExpert »
SECTION II. METROLOGICAL »
I Organizational and technical bases of metrological support »
2 Technical basics of metrological support »
2.3 Verification, calibration and testing of measuring instruments »
2.3.8 Measurements of electrical and magnetic quantities, radio engineering and radio electronic measurements »
ISO classifier »
17 METROLOGY AND MEASUREMENTS. PHYSICAL PHENOMENA »
17.020 Metrology and measurements in general »
National standards »
17 METROLOGY AND MEASUREMENTS. PHYSICAL PHENOMENA »
17.020 Metrology and measurements in general »
National Standards for KGS (State Standards Classification) »
Latest edition »
T General technical and organizational and methodological standards »
T8 State measurement system »
T88 Methods of verification and metrological certification »
As a Replacement Of:
GOST 8.216-88: State system for ensuring the uniformity of measurements. Voltage transformers. Verification methods
The Document References:
GOST 12.1.019-2017: Occupational safety standards system. Electrical safety. General requirements and nomenclature of types of protection
GOST 12.1.019-79: Occupational safety standards system. Electric safety. General requirements and nomenclature of kinds of protection
GOST 12.2.003-91: Industrial equipment. General safety requirements
GOST 12.2.007.0-75: Occupation safety standards system Electrical equipment. General safety requirements
GOST 12.2.007.14-75: Cables and cable fittings. Safety requirements
GOST 12.2.007.3-75: Occupational safety standard system. Electrotechnical devices for voltage more than 1 000 v
GOST 12.2.007.7-83: Occupation safety standards system. Safety requirements. Factory-built assemblies of regulating equipment
GOST 12.3.019-80: Occupational safety standards system. Electrical tests and measurements. General safety requirements
GOST 13109-97: Electric energy. Electromagnetic compatibility of technical equipment. Power quality limits in public electrical systems
GOST 1516.1-76: Electrical equipment for ac voltages of 3 to 500 kv
GOST 1516.2-97: Electrical equipment and installations for a.c. voltage 3 kV and higher. General methods of dielectric tests
GOST 18685-73: Current and voltage transformers. Terms and definitions
GOST 1983-2001: Voltage transformers. General specifications
GOST 1983-2015: Voltage transformers. General specifications
GOST 22261-94: Measuring instruments for electrical
GOST 22789-94: Low-voltage unitized devices
GOST 23625-2001: Measuring laboratory voltage transformers. General specifications
GOST 32144-2013: Electric energy. Electromagnetic compatibility of technical equipment. Power quality limits in the public power supply systems
GOST 3484.1-88: Power transformers. Electromagnetic test methods
GOST 8711-93: Direct acting indicating analogue electrical measuring instruments and their accessories. Part 2. Special requirements for ammeters and voltmeters
GOST R 12.1.019-2009: Occupational safety standards system. Electrical safety. General requirements and nomenclature of kinds of protection
GOST R 51321.1-2007: Low-voltage switchgear and control gear assemblies. Part 1. Type-tested and partially type-tested assemblies. General technical requirements and test methods
POT R M-016-2001: Inter-Industry Occupational Safety and Health Regulations (Safety Regulations) for Operation of Electrical Installations
PR 50.2.012-94: GSOEI. The procedure for certification of measuring instruments
RMG 29-99: State system for ensuring the uniformity of measurements. Metrology. Basic terms and definitions
The Document is Referenced By:
GOST 1983-2015: Voltage transformers. General specifications
MI 2999-2018: State system for ensuring uniformity of measurements. Systems automated information-measuring commercial accounting of electric energy. Recommendations for writing a type description
MI 3000-2018: Recommendation. State system for ensuring uniformity of measurements. Systems automated information-measuring commercial accounting of electric energy. Method of verification
MI 3314-2011: State system for ensuring uniformity of measurements. Measuring voltage transformers 220
MI 3591-17: GSI. Measuring voltage transformers with rated primary voltage from 0.1 to 0.8 kV. On-site verification procedure using the Energomonitor-3.1KM device
MP 001-2020: System automated information and measuring commercial accounting of electricity (AIIS KUE) Severstal Ropes JSC Volgogradsky Branch. Verification Method
MP 135-2019: System automated information-measuring commercial accounting of electricity (AIIS KUE) PJSC "Penzmash". Verification Method
MP 140-2019: Automated information-measuring system for commercial accounting of electric energy (AIIS KUE) of Transneft PJSC in the part of Transneft Vostok LLC at pump station No. 7
MP 206.1-176-2018: Automated information-measuring system for commercial accounting of electricity (AIIS KUE) of the traction substation "Kirenga" of the East Siberian Railway branch of the Russian Railways OJSC within the boundaries of the Irkutsk Region
MP 206.1-230-2018: System automated information and measuring commercial accounting of electricity (AIIS KUE) of PJSC
MP 312235-076-2020: System automated information measuring commercial accounting of electricity AIIS KUE UNEG PS 220 kV Megion. Verification Method
MP 312235-077-2020: RUSENERGOSBYT LLC automated information measuring system for commercial accounting of electric energy (AIIS KUE) for energy supply of the branch of BUNGE CIS LLC in Kolodeznoye. Verification Method
MP 471-2019: System automated information-measuring commercial accounting of electric power of UNEG PS 220 kV A-20 (technological connection to outdoor switchgear-110 kV and indoor switchgear-10 kV)
MP 471-2019: System automated information-measuring commercial accounting of electric power of UNEG PS 220 kV A-20 (technological connection to outdoor switchgear-110 kV and indoor switchgear-10 kV)
MP 472-2019: System automated information-measuring commercial accounting of electricity UNEG PS 220 kV Afipskaya (cable line 110 kV Afipskaya - Naumenkovskaya No. 1, No. 2)
MP 472-2019: System automated information-measuring commercial accounting of electricity UNEG PS 220 kV Afipskaya (cable line 110 kV Afipskaya - Naumenkovskaya No. 1, No. 2)
MP 473-2019: Automated information and measuring system for commercial accounting of electricity at UNEG SS 220 kV Vyshesteblievskaya (IIK VL 220 kV Vyshesteblievskaya - Taman 2)
MP 473-2019: Automated information and measuring system for commercial accounting of electricity at UNEG SS 220 kV Vyshesteblievskaya (IIK VL 220 kV Vyshesteblievskaya - Taman 2)
MP KCSM-177-2019: System automated information measuring commercial accounting of electricity LLC "Terbunsky potter". Verification Method
MP KCSM-186-2019: Channels measuring systems of automated information-measuring commercial metering of electricity AIIS KUE UNEG Substation 330 kV "Gubkin". Verification method
PNST 319-2018: Measuring transformers. Part 3. Specifications for inductive voltage transformers
|
Customers Who Viewed This Item Also Viewed:
 |
Controllers acting without
Language: English |
Building materials. Methods for combustibility test
Language: English |
Building materials spread flame test method
Language: English |
Polyvinyl chloride insulated cables of rated voltages up to and including 450/750 V. Non-sheathed cables for fixed wiring
Language: English |
Clear sheet glass. Specifications
Language: English |
Natural gas. Methods of calculation of physical properties. Calculation of physical properties on base information on density of standards conditions and nitrogen and carbon dioxide contents
Language: English |
Steel welded vessels and apparatus. General technical conditions
Language: English |
System of Standards for Occupational Safety and Health (SSBT). Personal protective equipment for respiratory organs. Self-rescuers insulating on chemically bound or with compressed oxygen. Technical requirements. Test methods. Marking. Sampling rules
Language: English |
 |
|
YOUR ORDERING MADE EASY!
RussianGost.com is an industry-leading company with stringent quality control standards and our dedication to precision, reliability and accuracy are some of the reasons why some of the world’s largest companies trust us to provide their national regulatory framework and for translations of critical, challenging, and sensitive information.
Our niche specialty is the localization of national regulatory databases involving: technical norms, standards, and regulations; government laws, codes, and resolutions; as well as RF agency codes, requirements, and Instructions.
We maintain a database of over 220,000 normative documents in English and other languages for the following 12 countries: Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Mongolia, Russia, Tajikistan, Turkmenistan, Ukraine, and Uzbekistan.
Placing Your Order
Please select your chosen document, proceed to the ‘checkout page’ and select the form of payment of your choice. We accept all major credit cards and bank wire transfers. We also accept PayPal and Google Checkout for your convenience. Please contact us for any additional arrangements (Contract agreements, PO, etc.).
Once an order is placed it will be verified and processed within a few hours up to a rare maximum of 24 hours.
For items in stock, the document/web link is e-mailed to you so that you can download and save it for your records.
For items out of stock (third party supply) you will be notified as to which items will require additional time to fulfil. We normally supply such items in less than three days.
Once an order is placed you will receive a receipt/invoice that can be filed for reporting and accounting purposes. This receipt can be easily saved and printed for your records.
Your Order Best Quality and Authenticity Guarantee
Your order is provided in electronic format (usually an Adobe Acrobat or MS Word).
We always guarantee the best quality for all of our products. If for any reason whatsoever you are not satisfied, we can conduct a completely FREE revision and edit of products you have purchased. Additionally we provide FREE regulatory updates if, for instance, the document has a newer version at the date of purchase.
We guarantee authenticity. Each document in English is verified against the original and official version. We only use official regulatory sources to make sure you have the most recent version of the document, all from reliable official sources.
