GOST R 55163-2012
ГОСТ Р 55163-2012
|
|
Mining equipment. Underground self-propelled cars. Safety requirements and test methods
Оборудование горно-шахтное. Вагоны самоходные подземные. Требования безопасности и методы испытаний
Status: Effective - Introduced for the first time. IUS 10-2014
This standard establishes safety requirements for the design of self-propelled pneumatic-wheel cars with bottom scraper conveyor in a bunker-body (hereinafter - cars) intended for delivery from roadheaders, loading machines of continuous action, hoppers - loaders of low-abrasive rock mass to overload sites main transport or in the ore passes through the mine workings of coal mines and mines, including hazardous gas (methane) and / or dust (coal, sulphide, sulphate) and ground construction, in conditions: - type 1 atmosphere according to GOST 15150 with air dustiness of not more than 300 mg / cubic meter. - relative air humidity up to 100% at a temperature of 25 ° С; - ambient temperature from + 40 ° С to minus 25 ° С; - height above sea level no more than 2000 m; - longitudinal slope of the path to ± 15 °; - sizes of pieces of transported rock mass not more than 700 mm; - carrying capacity of the soil generation (without special paving) of at least 200 N / cm square. The standard establishes safety requirements for wagons during their design, manufacture, certification and methods for monitoring safety performance.
Настоящий стандарт устанавливает требования безопасности к конструкции самоходных подземных вагонов на пневмоколесном ходу с донным скребковым конвейером в бункере-кузове (далее - вагоны), предназначенных для доставки от проходческих комбайнов, погрузочных машин непрерывного действия, бункеров - перегружателей малоабразивной горной массы до мест перегрузки на средства основного транспорта или в рудоспуски по горным выработкам угольных шахт и рудников, в том числе опасных по газу (метану) и/или пыли (угольной, сульфидной, сульфатной) и подземном строительстве, в условиях: - атмосферы типа 1 по ГОСТ 15150 при запыленности воздуха не более 300 мг/м куб. - относительной влажности воздуха до 100% при температуре 25 °С; - температуры окружающей среды от плюс 40 °С до минус 25 °С; - высоты над уровнем моря не более 2000 м; - продольного уклона пути до ± 15°; - размеров кусков транспортируемой горной массы не более 700 мм; - несущей способности почвы выработки (без специального дорожного покрытия) не менее 200 Н/см кв. Стандарт устанавливает требования безопасности к вагонам при их проектировании, изготовлении, сертификации и методы контроля показателей безопасности
Choose Language:
Format: Electronic (pdf/doc)
Approved: Federal Agency for Technical Regulation and Metrology,
11/22/2012
SKU: RUSS71511
The Product is Contained in the Following Classifiers:
PromExpert »
SECTION III. LABOR PROTECTION AND SAFETY »
III Occupational safety requirements for production equipment and processes »
2 Safety requirements for certain types of work »
2.2 Operation of production machines and equipment »
PromExpert »
SECTION I. TECHNICAL REGULATION »
V Testing and control »
4 Testing and control of products »
4.13 Testing and control of products of engineering industry »
4.13.2 Machines and equipment for special purposes »
4.13.2.4 Machines and equipment for mining, oil industry and quarrying »
ISO classifier »
73 MINING AND MINERAL PRODUCTS »
73.100 Mining equipment »
73.100.40 Equipment for haulage and lifting »
National standards »
73 MINING AND MINERAL PRODUCTS »
73.100 Mining equipment »
73.100.40 Equipment for haulage and lifting »
The Document References:
GOST 12.1.016-79: Work area air
GOST 12.1.044-89: Fire and explosion hazard of substances and materials. Nomenclature of indices and methods of their determination
GOST 12.1.050-86: Occupational safety standards system. Methods of noise measurement at work-places
GOST 12.2.003-91: Industrial equipment. General safety requirements
GOST 12.2.007.0-75: Occupation safety standards system Electrical equipment. General safety requirements
GOST 12.2.049-80: Occupational safety standards system. Industrial equipment. General ergonomic requirements
GOST 12.2.106-85: Occupational safety standards system. Machines and mechanisms for mining of ore, non-ore and placer deposits. General hygienic requirements and methods of testing
GOST 12971-67: Rectangular plates for machines and devices. Dimensions
GOST 13837-79: General purpose dynamometers
GOST 14192-96: Cargo marking
GOST 14254-96: Degrees of protection provided by enclosures (IP Code)
GOST 15150-69: Machines, instruments and other industrial products. Modifications for different climatic regions. Categories, operating, storage and transportation conditions as to environment climatic aspects influence
GOST 166-89: Vernier callipers. Specifications
GOST 17168-82: Octave and one-third-of-octave electronic filters
GOST 17187-2010: Noise meters Part 1 Technical requirements
GOST 2.601-2006: Unified system for design documentation. Exploitative documents
GOST 2405-88: Pressure gauges, vacuum gauges, pressure-vacuum gauges, pressure meters, draft gauges and draft-pressure gauges
GOST 24754-81: General purpose mining electric equipment
GOST 27254-87: Earth-moving machinery. Rubber tire machines steering capability
GOST 27257-87: Earth-moving machinery. Measurement of turning dimensions of wheeled machines
GOST 28498-90: Liquid-in-glass thermometers
GOST 31319-2006: Vibration. Measurement and evaluation of human exposure to whole-body vibration. Practical guidance for measurement at the workplace
GOST 31438.2-2011: Explosive atmospheres. Explosion protection and prevention. Part 2. Basic concepts and methodology (for mining)
GOST 31439-2011: Equipment and components intended for use in potentially explosive atmospheres in underground mines
GOST 31440.2-2011: Reciprocating internal combustion engines. Safety requirements for design and construction of engines for use in potentially explosive atmospheres. Part 2. Group I engines for use in underground workings susceptible to fired amp and/or combustible dust
GOST 31441.1-2011: Non-electrical equipment for potentially explosive atmospheres. Part 1. General requirements
GOST 31441.5-2011: Non-electrical equipment for potentially explosive atmospheres. Part 5. Protection by constructional safety «c»
GOST 31613-2012: Static electricity spark safety. General technical requirements and test methods
GOST 427-75: Measuring metal rules. Basic parameters and dimensions. Specifications
GOST 7502-98: Measuring metal tapes. Specifications
GOST R 12.4.026-2001: Occupational safety standards system. Safety colors, safety signs and signal marking. Purpose and rules of application. General technical requirements and characteristics. Test methods
GOST R 51330.20-99: Mining electrical equipment. Insulation, leakage paths and electrical gaps. Technical requirements and testing methods
GOST R 52230-2004: Electrical equipment for vehicles and tractors. General specifications
GOST R 52543-2006: Hydraulic drives. Safety requirements
GOST R 53648-2009: Underground diesel locomotives. General technical requirements and test methods
GOST R IEC 60079-0-2011: Explosive atmospheres. Part 0. Equipment. General requirements
GOST R IEC 60079-35-1-2011: Caplights for use in mines susceptible to firedamp. Part 1. General requirements and test methods in relation to the risk of explosion
GOST R ISO 3450-99: Earth-moving machinery. Braking systems of rubber-tyred machines. Systems and performance requirements and test procedures
PB 03-428-02: Safety Requirements for Construction of Underground Structures
PB 03-553-03: Uniform Safety Requirements for Underground Development of Ore, Non-Ore, and Placer Mineral Deposits
PB 05-618-03: Coal Mine Safety Regulations
SN 2.2.4/2.1.8.562-96: Noise exposure in work environment, residential premises, premises of public buildings and in dwellings zones
SN 2.2.4/2.1.8.566-96: Industrial vibration. Vibration in premises of residential and public buildings
Customers Who Viewed This Item Also Viewed:
 |
Building materials. Methods for combustibility test
Language: English |
Cylindrical evolvent gears of external engagment. Strength calculation
Language: English |
Building materials spread flame test method
Language: English |
Food products, food raw materials. Method for determination of the non-steroidal anti-inflammatory drug residue content by high performance liquid chromatography – mass spectrometry
Language: English |
Steel welded vessels and apparatus. General technical conditions
Language: English |
Plywood for general use with outer layers of deciduous veneer. Specifications
Language: English |
System of Standards for Occupational Safety and Health (SSBT). Personal protective equipment for respiratory organs. Self-rescuers insulating on chemically bound or with compressed oxygen. Technical requirements. Test methods. Marking. Sampling rules
Language: English |
 |
|
YOUR ORDERING MADE EASY!
RussianGost.com is an industry-leading company with stringent quality control standards and our dedication to precision, reliability and accuracy are some of the reasons why some of the world’s largest companies trust us to provide their national regulatory framework and for translations of critical, challenging, and sensitive information.
Our niche specialty is the localization of national regulatory databases involving: technical norms, standards, and regulations; government laws, codes, and resolutions; as well as RF agency codes, requirements, and Instructions.
We maintain a database of over 220,000 normative documents in English and other languages for the following 12 countries: Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Mongolia, Russia, Tajikistan, Turkmenistan, Ukraine, and Uzbekistan.
Placing Your Order
Please select your chosen document, proceed to the ‘checkout page’ and select the form of payment of your choice. We accept all major credit cards and bank wire transfers. We also accept PayPal and Google Checkout for your convenience. Please contact us for any additional arrangements (Contract agreements, PO, etc.).
Once an order is placed it will be verified and processed within a few hours up to a rare maximum of 24 hours.
For items in stock, the document/web link is e-mailed to you so that you can download and save it for your records.
For items out of stock (third party supply) you will be notified as to which items will require additional time to fulfil. We normally supply such items in less than three days.
Once an order is placed you will receive a receipt/invoice that can be filed for reporting and accounting purposes. This receipt can be easily saved and printed for your records.
Your Order Best Quality and Authenticity Guarantee
Your order is provided in electronic format (usually an Adobe Acrobat or MS Word).
We always guarantee the best quality for all of our products. If for any reason whatsoever you are not satisfied, we can conduct a completely FREE revision and edit of products you have purchased. Additionally we provide FREE regulatory updates if, for instance, the document has a newer version at the date of purchase.
We guarantee authenticity. Each document in English is verified against the original and official version. We only use official regulatory sources to make sure you have the most recent version of the document, all from reliable official sources.