GOST R 51992-2002
ГОСТ Р 51992-2002
|
|
Surge protective devices connected to low-voltage power distribution systems. Part 1. Performance requirements and testing methods
Устройства для защиты от импульсных перенапряжений в низковольтных силовых распределительных системах. Часть 1. Требования к работоспособности и методы испытаний
Status: Not effective - Superseded. IUS 6-2012
This standard applies to devices for the protection of electrical networks and electrical equipment under the direct or indirect impact of lightning or other transient overvoltages. These devices are designed to be connected to AC power circuits with a frequency of 50-60 Hz or DC and to equipment with a rated voltage up to 1000 V (RMS) or 1500 V DC
Настоящий стандарт распространяется на устройства для защиты электрических сетей и электрооборудования при прямом или косвенном воздействии грозовых или иных переходных перенапряжений. Данные устройства предназначены для подсоединения к силовым цепям переменного тока частотой 50-60 Гц или постоянного тока и к оборудованию на номинальное напряжение до 1000 В (действующее значение) или 1500 В постоянного тока
Choose Language:
Format: Electronic (pdf/doc)
Approved: Gosstandart of Russia,
12/25/2002
SKU: RUSS72569
The Product is Contained in the Following Classifiers:
ISO classifier »
29 ELECTRICAL ENGINEERING »
29.130 Switching and control equipment »
29.130.20 Low-voltage switching equipment and control equipment »
National standards »
29 ELECTRICAL ENGINEERING »
29.130 Switching and control equipment »
29.130.20 Low-voltage switching equipment and control equipment »
National Standards for KGS (State Standards Classification) »
Latest edition »
E Power and electrical equipment »
E7 Electrical apparatus and fittings »
E71 Devices with voltage up to 1000 V »
The Document is Replaced With:
GOST R 51992-2011: Low-voltage surge protective devices. Part 1. Surge protective devices connected to low-voltage power distribution systems. Technical requirements and test methods
The Document References:
GOST 12.2.007.6-75: Occupation safety standards system. Safety requirements. Switching devices for voltages below 1000 v
GOST 14254-96: Degrees of protection provided by enclosures (IP Code)
GOST 15150-69: Machines, instruments and other industrial products. Modifications for different climatic regions. Categories, operating, storage and transportation conditions as to environment climatic aspects influence
GOST 15543.1-89: Electrical articles. General requirements for environmental climatic aspects stability
GOST 16504-81: The state system of testing products. Product test and quality inspection. General terms and definitions
GOST 16962.1-89: Electrical articles. Test methods as to environments climatic factors resistance
GOST 16962.2-90: Electrotechnical product
GOST 17516.1-90: Electrical articles. General requirement for environment mechanical stability
GOST 18620-86: Electrotechnical articles
GOST 23216-78: Electrotechnical products. Storage, transportation, temporary corrosion protection and packing. General requirements and test methods
GOST 24753-81: Contact terminals of electrical equipment
GOST 27473-87: Method for determining the comparative and the proof tracking indices of solid insulating materials under moist conditions
GOST 9.005-72: Unified system of corrosion and ageing protection. Metals, alloys, metallic and non-metallic coatings. Permissible and impermissible contacts with metals and non-metals
GOST R 15.201-2000: System of product development and launching into manufacture. Products of industrial and technical designation. Procedure of product development and launching into manufacture
GOST R 50030.1-2000: Low-voltage switchgear and controlgear. Part 1. General rules and test methods
GOST R 50030.5.1-99: Low-voltage switchgear and control gear. Part 5.1. Control circuit devices and switching elements. Electromechanical control circuit devices
GOST R 50345-99: Electrical accessories. Circuit-breakers for overcurrent protection for household and similar installations
GOST R 50571.19-2000: Electrical installations of buildings. Part 4. Protection for safety. Chapter 44. Protection against overvoltages. Section 443. Protection against overvoltages of atmospheric origin or due to switching
GOST R 50571.26-2002: Electrical installations of buildings. Part 5. Selection and erection of electrical equipment. Section 534. Devices for protection against surge overvoltages
GOST R 51322.1-99: Plugs and socket-outlets for household and similar purposes. Part 1. Requirements and methods of tests
GOST R 51326.1-99: Residual current operated circuit-breakers without integral overcurrent protection for household and similar uses (RCCB's). Part 1. General requirements and test methods
GOST R 51686.1-2000: Connecting devices. Electrical copper conductors. Safety requirements for screw-type and screwless-type clamping units. Part 1. General requirements and particular requirements for clamping units for conductors from 0,2 up to 35 sq. mm (included)
GOST R 51686.2-2000: Connecting devices. Safety requirements for screw-type and screwless-type clamping units for electrical copper conductors. Part 2. Particular requirements for conductors from 35 up to 300 sq mm
GOST R IEC 227-7-98: Polyvinyl chloride insulated cables of rated voltages up to and including 450/750 V. Screened and unscreened flexible cables with two or more conductors
GOST R IEC 245-5-97: Rubber insulated cables of rated voltages up and including 450/750 V. Lift cables
GOST R IEC 60227-1-99: Polyvinyl chloride insulated cables of rated voltages up to and including 450/750 V. General requirements
GOST R IEC 60227-2-99: Polyvinylchloride insulated cables of rated voltages up to and including 450/750 V. Part 2. Test methods
GOST R IEC 60227-3-2002: Polyvinyl chloride insulated cables of rated voltages up to and including 450/750 V. Non-sheathed cables for fixed wiring
GOST R IEC 60227-4-2002: PVC-insulated cables for rated voltage up to and including 450/750 V. Sheathed cables for fixed installation
GOST R IEC 60227-5-2002: Polyvinyl chloride insulated cables of rated voltages up to and including 450/750 V. Flexible cables (cords)
GOST R IEC 60227-6-2002: Polyvinyl chloride insulated cables of rated voltages up to and including 450/750 V. Lift cables and cables for flexible connections
GOST R IEC 60245-1-97: Rubber insulated cables of rated voltages to 450/750 V including. General requirements
GOST R IEC 60245-2-2002: Rubber insulated cables of rated voltages up to and including 450/750 V. Test methods
GOST R IEC 60245-3-97: Rubber insulated cables of rated voltages to 450/750 V including. Heat resistant silicone insulated cables
GOST R IEC 60245-4-2002: Rubber insulated cables of rated voltages up to and including 450/750 V. Cords and flexible cables
GOST R IEC 60245-5-97: Rubber insulated cables of rated voltages to 450/750 V including. Part 5. Lift cables
GOST R IEC 60245-6-97: Rubber insulated cables of rated voltages to 450/750 V including. Arc welding electrode cables
GOST R IEC 60245-7-97: Rubber insulated cables of rated voltages to 450/750 V including. Heat-resistant ethylene-vinyl acetate rubber insulated cables
The Document is Referenced By:
GOST R 50571.26-2002: Electrical installations of buildings. Part 5. Selection and erection of electrical equipment. Section 534. Devices for protection against surge overvoltages
GOST R 51992-2011: Low-voltage surge protective devices. Part 1. Surge protective devices connected to low-voltage power distribution systems. Technical requirements and test methods
GOST R 52161.1-2004: Safety of household and similar electrical appliances. Part 1. General requirements
GOST R IEC 60950-22-2009: Information technology equipment. Safety. Part 22. Equipment to be installed outdoors
GOST R IEC 61643-12-2011: Low-voltage surge protective devices. Part 12. Surge protective devices connected to low-voltage power distribution systems. Selection and application principles
|
Customers Who Viewed This Item Also Viewed:
 |
Cylindrical evolvent gears of external engagment. Strength calculation
Language: English |
Unified system for design documentation. Types and sets of design documentation
Language: English |
Loads and impacts
Language: English |
High strength rolled steel. General specification
Language: English |
Food products, food raw materials. Method for determination of the non-steroidal anti-inflammatory drug residue content by high performance liquid chromatography – mass spectrometry
Language: English |
Plywood for general use with outer layers of deciduous veneer. Specifications
Language: English |
 |
|
YOUR ORDERING MADE EASY!
RussianGost.com is an industry-leading company with stringent quality control standards and our dedication to precision, reliability and accuracy are some of the reasons why some of the world’s largest companies trust us to provide their national regulatory framework and for translations of critical, challenging, and sensitive information.
Our niche specialty is the localization of national regulatory databases involving: technical norms, standards, and regulations; government laws, codes, and resolutions; as well as RF agency codes, requirements, and Instructions.
We maintain a database of over 220,000 normative documents in English and other languages for the following 12 countries: Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Mongolia, Russia, Tajikistan, Turkmenistan, Ukraine, and Uzbekistan.
Placing Your Order
Please select your chosen document, proceed to the ‘checkout page’ and select the form of payment of your choice. We accept all major credit cards and bank wire transfers. We also accept PayPal and Google Checkout for your convenience. Please contact us for any additional arrangements (Contract agreements, PO, etc.).
Once an order is placed it will be verified and processed within a few hours up to a rare maximum of 24 hours.
For items in stock, the document/web link is e-mailed to you so that you can download and save it for your records.
For items out of stock (third party supply) you will be notified as to which items will require additional time to fulfil. We normally supply such items in less than three days.
Once an order is placed you will receive a receipt/invoice that can be filed for reporting and accounting purposes. This receipt can be easily saved and printed for your records.
Your Order Best Quality and Authenticity Guarantee
Your order is provided in electronic format (usually an Adobe Acrobat or MS Word).
We always guarantee the best quality for all of our products. If for any reason whatsoever you are not satisfied, we can conduct a completely FREE revision and edit of products you have purchased. Additionally we provide FREE regulatory updates if, for instance, the document has a newer version at the date of purchase.
We guarantee authenticity. Each document in English is verified against the original and official version. We only use official regulatory sources to make sure you have the most recent version of the document, all from reliable official sources.
