GOST R 53635-2009
ГОСТ Р 53635-2009
|
|
Gas-fired air heaters with forced convection for firing (heating) rooms not exceeding a net heat input of 100 kW. General technical requirements and test methods
Газовые воздухонагреватели с принудительной конвекцией для отопления (обогрева) помещений теплопроизводительностью до 100 кВт. Общие технические требования и методы испытаний
Status: Effective - Introduced for the first time
This standard establishes the requirements for safety, design, characteristics and test methods of gas air heaters with forced convection (warm air generators using gas combustion for heating air) intended for residential heating, with one or more atmospheric burners, with an open or sealed combustion chamber without fans to supply air to the combustion zone and / or to remove gaseous products of combustion. This standard applies to appliances of type B11, B11AS, B11BS, C11, C21, C31 and C41 with a rated thermal output of not more than 100 kW, which are intended for use in premises consisting, as a rule, of only one living room. Heat transfer can be carried out through ducts. This standard does not apply to the following devices: - devices for installation in the open air; - Combined devices in air conditioners (for heating and cooling); - devices in which air is heated by means of an intermediate fluid; - devices with burners on fake; - devices with a manual or automatic device for adjusting the flow rate of air supplied to the combustion zone or removal of gaseous products of combustion (including chimney dampers); - portable or transported air heaters with forced convection; - devices with multiple heating elements, equipped with only one stabilizer thrust; - appliances equipped with more than one exhaust of combustion gases; - devices of types C21 and C41, operated with gases of the third family
Настоящий стандарт устанавливает требования к безопасности, конструкции, характеристикам и методам испытаний газовых воздухонагревателей с принудительной конвекцией (генераторов теплого воздуха, использующих для обогрева воздуха сжигание газов), предназначенных для отопления жилых помещений, с одной или несколькими атмосферными горелками, с открытой или герметичной камерой сгорания без вентиляторов для подачи воздуха в зону горения и/или для удаления газообразных продуктов сгорания. Настоящий стандарт распространяется на приборы типов B11, B11AS, B11BS, C11, C21, C31 и C41 с номинальной тепловой мощностью не более 100 кВт, которые предназначены для использования в помещениях, состоящих, как правило, только из одной жилой комнаты. Теплообмен может осуществляться по воздуховодам. Настоящий стандарт не распространяется на следующие приборы: - приборы для установки на открытом воздухе; - комбинированные приборы в кондиционерах (для нагрева и охлаждения); - приборы, в которых воздух нагревается при помощи промежуточной жидкости; - приборы с горелками на искусственной тяге; - приборы с ручным или автоматическим устройством для настройки расхода подводимого в зону горения воздуха или отвода газообразных продуктов сгорания (включая заслонки дымоходов); - переносные или транспортируемые воздухонагреватели с принудительной конвекцией; - приборы с несколькими нагревательными элементами, оснащенные только одним стабилизатором тяги; - приборы, оснащенные более чем одним отводом газообразных продуктов сгорания; - приборы типов С21 и С41, эксплуатируемые с газами третьего семейств
Choose Language:
Format: Electronic (pdf/doc)
Approved: Federal Agency for Technical Regulation and Metrology,
12/15/2009
SKU: RUSS73427
The Product is Contained in the Following Classifiers:
Construction (Max) »
Standards »
Other state standards used in construction »
91 Building materials and construction »
Evidence base (TR CU, Technical Regulation of the Customs Union) »
016/2011 TR CU. On safety of gaseous fuel machines »
Regulations and standards (to ТР ТС ТС 016/2011) »
PromExpert »
SECTION III. LABOR PROTECTION AND SAFETY »
II Industrial sanitation and occupational health »
3 Workspace air »
3.2 Improvement of air environment and normalization of microclimate parameters »
PromExpert »
SECTION I. TECHNICAL REGULATION »
V Testing and control »
4 Testing and control of products »
4.13 Testing and control of products of engineering industry »
4.13.2 Machines and equipment for special purposes »
4.13.2.14 Fire equipment, machinery and equipment for public utilities »
ISO classifier »
91 CONSTRUCTION MATERIALS AND CONSTRUCTION »
91.140 Installations in buildings »
91.140.01 Engineering equipment of buildings in general »
National standards »
91 CONSTRUCTION MATERIALS AND CONSTRUCTION »
91.140 Installations in buildings »
91.140.01 Engineering equipment of buildings in general »
ISO classifier »
97 HOUSEHOLD APPLIANCES AND TRADE EQUIPMENT. RECREATION. SPORT »
97.100 Domestic, commercial and industrial heating appliances »
97.100.20 Gas Heaters »
National standards »
97 HOUSEHOLD APPLIANCES AND TRADE EQUIPMENT. RECREATION. SPORT »
97.100 Domestic, commercial and industrial heating appliances »
97.100.20 Gas Heaters »
National Standards for KGS (State Standards Classification) »
Latest edition »
G Machines, equipment and tools »
G4 Machinery and equipment for heavy industry »
G40 Classification, nomenclature and general rules »
The Document References:
Federal Law 184-FZ: About technical regulation
GOST 12815-80: Flanges for valves, fittings and pipelines for Pnom from 0,1 to 20 MPa (from 1 to 200 kgf/sq sm). Types. Connecting dimensions and dimensions of sealing surfaces
GOST 12969-67: Plates for machines and devices. Technical requirements
GOST 14192-96: Cargo marking
GOST 14254-96: Degrees of protection provided by enclosures (IP Code)
GOST 1494-77: Electrotechnics. Letter symbols for common quantities
GOST 20448-90: Liquefied hydrocarbon fuel gases for domestic use. Specifications
GOST 23358-87: Threaded pipe-line connections. Joint washers. Design
GOST 5542-87: Natural fuel gases for industrial and domestic use
GOST 6211-81: Conical pipe thread. Profile, basic dimensions and tolerances
GOST 6357-81: Basic norms of interchangeability pipe cylindrical thread
GOST R 1.0-2004: Standardization in the Russian Federation. Basic provisions
GOST R 51842-2001: Automatic shut-off valves for gas burners and gas appliances. General technical requirements and test methods
GOST R 51843-2001: Flame supervision devices for gas burning appliances. Thermo-electric flame supervision devices. General technical requirements and test methods
GOST R 51982-2002: Gas appliances pressure governors for inlet pressure up to 20 kPa. General technical requirements and test methods
GOST R 51983-2002: Multifunctional controls for gas burning appliances. General technical requirements and test methods
GOST R 52161.1-2004: Safety of household and similar electrical appliances. Part 1. General requirements
GOST R 52219-2004: Automatic control systems for gas burners and gas burning appliances. General technical requirements and test methods
GOST R EN 257-2004: Mechanical thermostats (thermoregulators) for gas appliances. General technical requirements and test methods
GOST R IEC 60730-1-2002: Automatic electrical controls for household and similar use. General requirements and test methods
GOST R IEC 61058.1-2000: Switches for electrical appliances. Part 1. General requirements and test methods
GOST R IEC 730-2-9-94: Automatic electrical controls for household and similar use. Particular requirements for temperature sensing controls and test methods
PB 12-529-03: Gas distribution and gas consumption system safety rules. Series 12. Revision 4.
PB 12-609-03: Safety rules for facilities using liquefied hydrocarbon gases
The Document is Referenced By:
Decision 86: On the list of international and regional (interstate) standards, and in their absence - national (state) standards, as a result of which, on a voluntary basis, compliance with the requirements of the technical regulations of the Customs Union "On the safety of devices operating on gaseous fuel" (TR CU 016 / 2011), and the list of international and regional (interstate) standards, and in their absence - national (state) standards containing rules and methods of research (testing) and measurements, including sampling rules necessary for the application and fulfillment of requirements technical regulations of the Customs Union "On the safety of devices operating on gaseous fuel" (TR CU 016/2011) and the implementation of conformity assessment of objects of technical regulation
|
Customers Who Viewed This Item Also Viewed:
 |
Unified system for design documentation. Types and sets of design documentation
Language: English |
Loads and impacts
Language: English |
Vessels and Apparatus. Norms and methods of strength calculation from wind loads, seismic influence and other external loads
Language: English |
Articulated connector devices with cast male and female parts for freight cars of articulated type. General technical specifications
Language: English |
 |
|
YOUR ORDERING MADE EASY!
RussianGost.com is an industry-leading company with stringent quality control standards and our dedication to precision, reliability and accuracy are some of the reasons why some of the world’s largest companies trust us to provide their national regulatory framework and for translations of critical, challenging, and sensitive information.
Our niche specialty is the localization of national regulatory databases involving: technical norms, standards, and regulations; government laws, codes, and resolutions; as well as RF agency codes, requirements, and Instructions.
We maintain a database of over 220,000 normative documents in English and other languages for the following 12 countries: Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Mongolia, Russia, Tajikistan, Turkmenistan, Ukraine, and Uzbekistan.
Placing Your Order
Please select your chosen document, proceed to the ‘checkout page’ and select the form of payment of your choice. We accept all major credit cards and bank wire transfers. We also accept PayPal and Google Checkout for your convenience. Please contact us for any additional arrangements (Contract agreements, PO, etc.).
Once an order is placed it will be verified and processed within a few hours up to a rare maximum of 24 hours.
For items in stock, the document/web link is e-mailed to you so that you can download and save it for your records.
For items out of stock (third party supply) you will be notified as to which items will require additional time to fulfil. We normally supply such items in less than three days.
Once an order is placed you will receive a receipt/invoice that can be filed for reporting and accounting purposes. This receipt can be easily saved and printed for your records.
Your Order Best Quality and Authenticity Guarantee
Your order is provided in electronic format (usually an Adobe Acrobat or MS Word).
We always guarantee the best quality for all of our products. If for any reason whatsoever you are not satisfied, we can conduct a completely FREE revision and edit of products you have purchased. Additionally we provide FREE regulatory updates if, for instance, the document has a newer version at the date of purchase.
We guarantee authenticity. Each document in English is verified against the original and official version. We only use official regulatory sources to make sure you have the most recent version of the document, all from reliable official sources.
