GOST IEC 61347-2-13-2013
ГОСТ IEC 61347-2-13-2013
|
|
Lamp control gear. Part 2-13. Particular requirements for d.c. or a.c. supplied electronic control gear for LED modules
Аппараты пускорегулирующие для ламп. Часть 2-13. Дополнительные требования к электронным пускорегулирующим аппаратам с напряжением питания постоянного или переменного тока для модулей со светоизлучающими диодами
Status: Effective - Introduced for the first time
This standard establishes additional safety requirements for electronic control gears (ECG) with a supply voltage of up to 250 V DC or up to 1000 V AC with a frequency of 50 or 60 Hz and with operating frequencies different from the frequency of the supply mains for connecting modules diodes (hereinafter referred to as LED modules). This standard applies to electronic ballasts designed to power LED modules with stabilized voltage or current with protection against electric shock using a safe extra-low voltage (BSNN) system or a system equivalent to the BSNN system, as well as to power LED modules with higher voltage. This standard is also applicable to electronic ballasts with unstabilized output voltage or current. For the purposes of this standard, the applications of Part 1 apply; The term "lamp" is also understood as "LED modules". Annex I establishes the requirements for electronic ballasts that are part of an electrical circuit. Performance requirements are set out in IEC 62384
Настоящий стандарт устанавливает дополнительные требования безопасности к электронным пускорегулирующим аппаратам (ЭПРА) с напряжением питания до 250 В постоянного тока или до 1000 В переменного тока с частотой 50 или 60 Гц и с рабочими частотами, отличающимися от частоты питающей сети, предназначенным для подключения модулей со светоизлучающими диодами (далее - модули СИД). Настоящий стандарт распространяется на ЭПРА, предназначенные для питания модулей СИД стабилизированным напряжением или током с защитой от поражения электрическим током с применением системы безопасного сверхнизкого напряжения (БСНН) или системы, эквивалентной системе БСНН, а также для питания модулей СИД более высоким напряжением. Настоящий стандарт также применим для ЭПРА с нестабилизированным выходным напряжением или током. Для целей настоящего стандарта применяют приложения части 1; под термином «лампа» при этом понимают также «модули СИД». В приложении I установлены требования к ЭПРА, которые являются частью электрической схемы. Требования к рабочим характеристикам установлены в IEC 62384
Choose Language:
Format: Electronic (pdf/doc)
Approved: Federal Agency for Technical Regulation and Metrology,
3/11/2014
SKU: RUSS73465
The Product is Contained in the Following Classifiers:
Construction (Max) »
Standards »
Other state standards used in construction »
29 Electrical Engineering »
Evidence base (TR CU, Technical Regulation of the Customs Union) »
004/2011 TR CU. About safety of low voltage equipment »
Regulations and standards (to TR CU 004/2011) »
ISO classifier »
29 ELECTRICAL ENGINEERING »
29.140 Lighting products »
29.140.99 Lamps, other aspects »
National standards »
29 ELECTRICAL ENGINEERING »
29.140 Lighting products »
29.140.99 Lamps, other aspects »
The Document is Replaced With:
GOST IEC 61347-2-13-2021: Control gear for lamps. Part 2-13. Additional requirements for electronic ballasts with DC or AC supply voltage for light-emitting diode modules.
The Document References:
GOST 10374-93: Direct acting indicating analogue electrical measuring instruments and their accessories. Part 7. Special requirements for multi-function instruments
GOST 23706-93: Direct action analog electrical
GOST 28018-89: Adhesive tape for electrical insulation
GOST 28019-89: Adhesive tape for electrical insulation. Test methods
GOST 28020-89: Adhesive electric insulation tapes
GOST 28021-89: Adhesive electric insulation tapes
GOST 28022-89: Adhesive electric insulation tapes
GOST 28023-89: Adhesive electric insulation tapes
GOST 28024-89: Adhesive electric insulation tapes
GOST 28025-89: Adhesive electric insulation tapes
GOST 28026-89: Adhesive electric insulation tapes
GOST 28027-89: Adhesive electric insulation tapes
GOST 28312-89: Radioelectronic equipment, professional. Conventional graphic designations
GOST 30012.1-2002: Direct acting indicating analogue electrical measuring instruments and their accessories. Part 1. Definitions and general requirements common to all parts
GOST 30012.9-93: Direct acting indicating analogue electrical measuring instruments and their accessories. Part 9. Methods of tests
GOST 30801.5-2012: Miniature fuses. Guide lines for quality assessment of miniature fuse-links
GOST 31196.2.1-2012: Low-voltage fuses. Part 2-1. Supplementary requirements for fuses for industrial application. Section I to III
GOST 31196.2-2012: Low-voltage fuses. Part 2. Supplementary requirements for fuses for industrial application
GOST 31196.3-2012: Low-voltage fuses. Part 3. Supplementary requirements for fuses for use by unskilled persons
GOST 7396.1-89: Plugs and socket-outlets for domestic and similar general use
GOST 7590-93: Direct acting indicating analogue electrical measuring instruments and their accessories. Part 4. Special requirements for frequency meters
GOST 8039-93: Direct acting indicating analogue electrical measuring instruments and their accessories. Part 5. Special requirements for phase meters, power factor meters and synchroscopes
GOST 8042-93: Direct acting indicating analogue electrical measuring instruments and their accessories. Part 8. Special requirements for accessories
GOST 8476-93: Direct acting indicating analogue electrical measuring instruments and their accessories. Part 3. Special requirements for wattmeters and varmeters
GOST 8711-93: Direct acting indicating analogue electrical measuring instruments and their accessories. Part 2. Special requirements for ammeters and voltmeters
GOST 8865-93: Electrical insulation system. Thermal evalution and classification
GOST IEC 60065-2011: Audio, video and similar electronic apparatus. Safety requirements
GOST IEC 60127-1-2010: Miniature fuses. Part 1. Definitions for miniature fuses and general requirements for miniature fuse-links
GOST IEC 60127-4-2011: Miniature fuses. Part 4. Universal modular fuse-links for through-hole and surface mount types
GOST IEC 60269-3-1-2011: Low-voltage fuses. Part 3-1. Supplementary requirements for fuses for use by unskilled persons (fuses mainly for household and similar applications). Sections I to IV
GOST IEC 60906-3-2011: IEC System of plugs and socket-outlets for household and similar purposes. Particular requirements for SELV plugs and sockets 6, 12, 24, 48 V, a. c. and d. c., 16 A. Technical requirements
GOST IEC 60950-1-2011: Information technology equipment. Safety. Part 1. General requirements
GOST R IEC 60384-14-2004: Fixed capacitors for use in electronic equipment. Part 14. Sectional specification on fixed capacitors for electromagnetic interference suppression and connection to the supply mains
The Document is Referenced By:
GOST IEC 60598-2-21-2017: Luminaires. Part 2-21. Particular requirements. Rope lights
GOST IEC 62031-2016: LED modules for general lighting. Safety specifications
GOST IEC 62384-2013: DC or AC supplied electronic control gear for LED modules. Performance requirements
PNST 117-2016: Luminaires. Part 2-21. Particular requirements. Rope lights
|
Customers Who Viewed This Item Also Viewed:
 |
Liquids for aircrafts systems. Method for determination thermo oxidizing stability and corrosion activity
Language: English |
Plastics structured-wall pipes and their fittings for sewerage systems outside the buildings. Specifications
Language: English |
 |
|
YOUR ORDERING MADE EASY!
RussianGost.com is an industry-leading company with stringent quality control standards and our dedication to precision, reliability and accuracy are some of the reasons why some of the world’s largest companies trust us to provide their national regulatory framework and for translations of critical, challenging, and sensitive information.
Our niche specialty is the localization of national regulatory databases involving: technical norms, standards, and regulations; government laws, codes, and resolutions; as well as RF agency codes, requirements, and Instructions.
We maintain a database of over 220,000 normative documents in English and other languages for the following 12 countries: Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Mongolia, Russia, Tajikistan, Turkmenistan, Ukraine, and Uzbekistan.
Placing Your Order
Please select your chosen document, proceed to the ‘checkout page’ and select the form of payment of your choice. We accept all major credit cards and bank wire transfers. We also accept PayPal and Google Checkout for your convenience. Please contact us for any additional arrangements (Contract agreements, PO, etc.).
Once an order is placed it will be verified and processed within a few hours up to a rare maximum of 24 hours.
For items in stock, the document/web link is e-mailed to you so that you can download and save it for your records.
For items out of stock (third party supply) you will be notified as to which items will require additional time to fulfil. We normally supply such items in less than three days.
Once an order is placed you will receive a receipt/invoice that can be filed for reporting and accounting purposes. This receipt can be easily saved and printed for your records.
Your Order Best Quality and Authenticity Guarantee
Your order is provided in electronic format (usually an Adobe Acrobat or MS Word).
We always guarantee the best quality for all of our products. If for any reason whatsoever you are not satisfied, we can conduct a completely FREE revision and edit of products you have purchased. Additionally we provide FREE regulatory updates if, for instance, the document has a newer version at the date of purchase.
We guarantee authenticity. Each document in English is verified against the original and official version. We only use official regulatory sources to make sure you have the most recent version of the document, all from reliable official sources.
