GOST R 54448-2011
ГОСТ Р 54448-2011
|
|
Single burner gas-fired overhead radiant tube heaters for non-domestic use. Part 1. Safety requirements
Нагреватели трубчатые радиационные газовые с одной горелкой, не предназначенные для бытового применения. Часть 1. Требования безопасности
Status: Effective - Introduced for the first time. IUS 9-2012
This standard defines the requirements and test methods in terms of design, safety, classification and labeling of non-residential ceiling gas tubular radiation heaters equipped with a single burner with an automatic control system. This standard is applicable to devices of type A2, A3, B12, B13, B22, B23, B42, B43, B52, B53, C12, C13, C32 C33, intended for use in all rooms except residential, in which the air supply for combustion and / or exhaust products of combustion is achieved by mechanical means placed in front of the air deflector (if the latter is provided). This standard is not applicable to devices: a) designed for use in residential premises; b) used on the street; c) with an effective thermal capacity of more than 120 kW (based on the net calorific value of the corresponding reference gas of comparison); d) with gas-air mixture burners, in which: - gas and all combustion air are mixed before entering the combustion zone; either - preliminary mixing of gas and all combustion air is carried out in a part of the burner in front of the combustion zone; e) designed for continuous condensation in the duct system under normal operating conditions; g) with non-metallic lines for exhausting combustion products
Настоящий стандарт определяет требования и методы испытаний в части конструкции, безопасности, классификации и маркировки не бытовых потолочных газовых трубчатых радиационных нагревателей, оборудованных одной горелкой с автоматической системой управления. Настоящий стандарт применим к аппаратам типа A2, A3, B12, B13, B22, B23, B42, B43, B52, B53, C12, C13, C32 C33, предназначенным для применения во всех помещениях, кроме жилых, в которых подача воздуха для горения и/или вытяжки продуктов сгорания достигается механическими средствами, размещенными перед воздушным дефлектором (если последний предусмотрен). Настоящий стандарт не применим для аппаратов: a) рассчитанных на применение в жилых помещениях; b) применяемых на улице; c) с эффективной тепловой мощностью более 120 кВт (из расчета чистой теплотворной способности соответствующего эталонного газа сравнения); d) с горелками, работающими на газовоздушной смеси, в которых : - газ и весь воздух для горения смешиваются до попадания в зону сгорания; либо - предварительное смешивание газа и всего воздуха для горения осуществляется в части горелки перед зоной сгорания; e) рассчитанных на непрерывную конденсацию в системе газоходов в нормальных условиях эксплуатации; g) с неметаллическими линиями отвода продуктов сгорания
Choose Language:
Format: Electronic (pdf/doc)
Approved: Federal Agency for Technical Regulation and Metrology,
9/28/2011
SKU: RUSS73669
The Product is Contained in the Following Classifiers:
Construction (Max) »
Standards »
Other state standards used in construction »
91 Building materials and construction »
Evidence base (TR CU, Technical Regulation of the Customs Union) »
016/2011 TR CU. On safety of gaseous fuel machines »
Regulations and standards (to ТР ТС ТС 016/2011) »
ISO classifier »
91 CONSTRUCTION MATERIALS AND CONSTRUCTION »
91.140 Installations in buildings »
91.140.40 Gas supply systems »
National standards »
91 CONSTRUCTION MATERIALS AND CONSTRUCTION »
91.140 Installations in buildings »
91.140.40 Gas supply systems »
National Standards for KGS (State Standards Classification) »
Latest edition »
E Power and electrical equipment »
E2 Steam-powered equipment »
E21 Steam Boilers »
The Document is Replaced With:
GOST R 54448-2023: Single-burner tubular radiant gas heaters and multi-burner tubular radiant gas heater systems not intended for domestic use. Safety requirements and energy efficiency
The Document References:
Federal Law 184-FZ: About technical regulation
GOST 12815-80: Flanges for valves, fittings and pipelines for Pnom from 0,1 to 20 MPa (from 1 to 200 kgf/sq sm). Types. Connecting dimensions and dimensions of sealing surfaces
GOST 12816-80: Flanges for valves, fittings and pipelines for Pnom from 0,1 to 20 MPa (from 1 to 200 kgf/sq sm). General technical requirements
GOST 12817-80: Cast grey iron flanges for Pnom from 0,1 to 1,6 MPa (from 1 to 16 kgf/sq sm). Design and dimensions
GOST 12818-80: Cast malleable iron flanges for Pnom from 1,6 to 4,0 MPa (from 16 to 40 kgf/cm2). Design and dimensions
GOST 12819-80: Cast steel flanges for Pnom from 1,6 to 20,0 MPa (from 16 to 200 kgf/sq sm). Design and dimensions
GOST 14254-96: Degrees of protection provided by enclosures (IP Code)
GOST 15763-2005: Threaded and flange pipe connections for PN to 63 MPa (to 630 kgf/sq sm). General specifications
GOST 15763-91: Pipeline thread connections for Py up to 63 MPa (up to 630 kgf/cm2)
GOST 16093-2004: Basic norms of interchangeability. Metric screw thread. Tolerances. Clearance fits
GOST 16093-81: Basic norms of interchangebility. Metric screw thread. Tolerances. Clearance fits
GOST 23358-87: Threaded pipe-line connections. Joint washers. Design
GOST 24705-2004: Вasic norms of interchangeability. Metric screw thread. Basic dimensions
GOST 24705-81: Basic norms of interchangeability. Metric screw thread. Basic dimensions
GOST 31369-2008: Natural gas. Calculation of calorific values, density, relative density and Wobbe index from composition
GOST 5542-87: Natural fuel gases for industrial and domestic use
GOST 6211-81: Conical pipe thread. Profile, basic dimensions and tolerances
GOST 6357-81: Basic norms of interchangeability pipe cylindrical thread
GOST R 1.0-2004: Standardization in the Russian Federation. Basic provisions
GOST R 1.5-2004: Standardization in the Russian Federation. National standards of the Russian Federation. Rules of structure, drafting, presentation and indication
GOST R 51842-2001: Automatic shut-off valves for gas burners and gas appliances. General technical requirements and test methods
GOST R 51982-2002: Gas appliances pressure governors for inlet pressure up to 20 kPa. General technical requirements and test methods
GOST R 51983-2002: Multifunctional controls for gas burning appliances. General technical requirements and test methods
GOST R 52161.1-2004: Safety of household and similar electrical appliances. Part 1. General requirements
GOST R 52219-2004: Automatic control systems for gas burners and gas burning appliances. General technical requirements and test methods
GOST R 52318-2005: Round copper tubes for water and gas. Specifications
GOST R 54449-2011: Single burner gas-fired overhead radiant tube heaters for non-domestic use. Part 2. Rational use of energy
GOST R EN 257-2004: Mechanical thermostats (thermoregulators) for gas appliances. General technical requirements and test methods
GOST R ISO 2859-1-2007: Statistical methods. Sampling procedures for inspection by attributes. Part 1. Sampling schemes indexed by acceptance quality limit for lot-by-lot inspection
GOST R ISO 9001-2008: Quality management systems. Requirements
The Document is Referenced By:
Decision 86: On the list of international and regional (interstate) standards, and in their absence - national (state) standards, as a result of which, on a voluntary basis, compliance with the requirements of the technical regulations of the Customs Union "On the safety of devices operating on gaseous fuel" (TR CU 016 / 2011), and the list of international and regional (interstate) standards, and in their absence - national (state) standards containing rules and methods of research (testing) and measurements, including sampling rules necessary for the application and fulfillment of requirements technical regulations of the Customs Union "On the safety of devices operating on gaseous fuel" (TR CU 016/2011) and the implementation of conformity assessment of objects of technical regulation
GOST R 54449-2011: Single burner gas-fired overhead radiant tube heaters for non-domestic use. Part 2. Rational use of energy
|
Customers Who Viewed This Item Also Viewed:
 |
Industrial process measurement and control equipment. Reliability. General requirements and test methods
Language: English |
Gauged corrosion-resistant, heat-resistant and high-temperature steel shape
Language: English |
System for ensuring the reliability and safety of construction sites. Loads and impacts. design standards
Language: English |
Heating, ventilation and air conditioning. Fire Safety Requirements
Language: English |
Reliability of atomic power stations and their equipment. General statements and reliability index nomenclature
Language: English |
Electromagnetic compatibility of technical equipment. Technical equipment for nuclear power plants. Requirement and test methods
Language: English |
Billets made of corrosion-resistant steels of 12Х18Н9Т, 12Х18Н10Т, 08Х18Н10Т, 10Х17Н13М2Т, 12Х18Н12Т and 03Х21Н32М3Б types.
Language: English |
Dependability in technics. Terms and definitions
Language: English |
System of products development and launching into manufacture. Technical assignment. Requirements to contents and form of presentation
Language: English |
Reliability in technology. Composition and general rules for setting reliability requirements
Language: English |
Rails of types P38 and P42. Technical conditions
Language: English |
Stainless corrosion resisting, heat-resisting and creep resisting steel and alloy on iron-nickel-based products. Specifications
Language: English |
Natural gas for industrial and municipal purposes. Technical conditions
Language: English |
 |
|
YOUR ORDERING MADE EASY!
RussianGost.com is an industry-leading company with stringent quality control standards and our dedication to precision, reliability and accuracy are some of the reasons why some of the world’s largest companies trust us to provide their national regulatory framework and for translations of critical, challenging, and sensitive information.
Our niche specialty is the localization of national regulatory databases involving: technical norms, standards, and regulations; government laws, codes, and resolutions; as well as RF agency codes, requirements, and Instructions.
We maintain a database of over 220,000 normative documents in English and other languages for the following 12 countries: Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Mongolia, Russia, Tajikistan, Turkmenistan, Ukraine, and Uzbekistan.
Placing Your Order
Please select your chosen document, proceed to the ‘checkout page’ and select the form of payment of your choice. We accept all major credit cards and bank wire transfers. We also accept PayPal and Google Checkout for your convenience. Please contact us for any additional arrangements (Contract agreements, PO, etc.).
Once an order is placed it will be verified and processed within a few hours up to a rare maximum of 24 hours.
For items in stock, the document/web link is e-mailed to you so that you can download and save it for your records.
For items out of stock (third party supply) you will be notified as to which items will require additional time to fulfil. We normally supply such items in less than three days.
Once an order is placed you will receive a receipt/invoice that can be filed for reporting and accounting purposes. This receipt can be easily saved and printed for your records.
Your Order Best Quality and Authenticity Guarantee
Your order is provided in electronic format (usually an Adobe Acrobat or MS Word).
We always guarantee the best quality for all of our products. If for any reason whatsoever you are not satisfied, we can conduct a completely FREE revision and edit of products you have purchased. Additionally we provide FREE regulatory updates if, for instance, the document has a newer version at the date of purchase.
We guarantee authenticity. Each document in English is verified against the original and official version. We only use official regulatory sources to make sure you have the most recent version of the document, all from reliable official sources.
