GOST R 50030.4.1-2012
ГОСТ Р 50030.4.1-2012
|
|
Low-voltage switchgear and control gear. Part 4. Contactors and motor-starters. Section 1. Electromechanical contactors and motor-starters
Аппаратура распределения и управления низковольтная. Часть 4. Контакторы и пускатели. Раздел 1. Электромеханические контакторы и пускатели
Status: Effective
This standard applies to devices of all kinds, the main contacts of which are supposed to be connected to circuits with a nominal voltage not higher than 1000 V AC or 1500 V DC. The contactors and starters specified in the standard are not intended to disconnect short-circuit currents. Therefore, appropriate protection against short circuits must be carried out by part of the installation, but not necessarily by a contactor or starter.
Настоящий стандарт распространяется на аппараты всех видов, главные контакты которых предполагается присоединять к цепям номинальным напряжением не выше 1000 В переменного или 1500 В постоянного тока. Контакторы и пускатели, указанные в стандарте не предназначены для отключения токов короткого замыкания. Поэтому соответствующая защита от коротких замыканий должна осуществляться частью установки, но не обязательно контактором или пускателем
Choose Language:
Format: Electronic (pdf/doc)
Approved: Federal Agency for Technical Regulation and Metrology,
9/17/2012
SKU: RUSS73884
The Product is Contained in the Following Classifiers:
Evidence base (TR CU, Technical Regulation of the Customs Union) »
004/2011 TR CU. About safety of low voltage equipment »
Regulations and standards (to TR CU 004/2011) »
Evidence base (TR CU, Technical Regulation of the Customs Union) »
020/2011 TR CU. Electromagnetic compatibility of technical means »
Regulations and standards (to ТР ТС ТС 020/2011) »
ISO classifier »
29 ELECTRICAL ENGINEERING »
29.120 Electrical fittings »
29.120.99 Other electrical fittings »
National standards »
29 ELECTRICAL ENGINEERING »
29.120 Electrical fittings »
29.120.99 Other electrical fittings »
ISO classifier »
29 ELECTRICAL ENGINEERING »
29.130 Switching and control equipment »
29.130.20 Low-voltage switching equipment and control equipment »
National standards »
29 ELECTRICAL ENGINEERING »
29.130 Switching and control equipment »
29.130.20 Low-voltage switching equipment and control equipment »
National Standards for KGS (State Standards Classification) »
Latest edition »
E Power and electrical equipment »
E7 Electrical apparatus and fittings »
E71 Devices with voltage up to 1000 V »
National Standards for OKSTU »
ELECTRICAL EQUIPMENT AND MATERIALS »
Electromagnetic contactors »
National Standards for OKSTU »
ELECTRICAL EQUIPMENT AND MATERIALS »
Electromagnetic starters »
As a Replacement Of:
GOST R 50030.4.1-2002: Low-voltage switchgear and controlgear. Part 4-1. Contactors and motor-starters. Electromechanical contactors and motor-starters
The Document References:
GOST 11478-88: Electronic consumer equipment. Norms and methods of climatic and environmental mechanical testing procedure
GOST 15.309-98: System of product development and launching into manufacture. Test and acceptance of produced goods. Principal positions
GOST 17441-84: Electrical contact connections. Acceptance and methods of tests
GOST 30830-2002: Power transformers. Part 1. General
GOST 9.005-72: Unified system of corrosion and ageing protection. Metals, alloys, metallic and non-metallic coatings. Permissible and impermissible contacts with metals and non-metals
GOST R 15.201-2000: System of product development and launching into manufacture. Products of industrial and technical designation. Procedure of product development and launching into manufacture
GOST R 50030.1-2007: Low-voltage switchgear and controlgear. Part 1. General rules
GOST R 50030.2-2010: Low-voltage switchgear and control gear. Part 2. Circuit-breakers
GOST R 50030.3-99: Low -voltage switchgear and controlgear. Pat 3. Switchers, disconnectors, switch-disconnectors and fure-combination units
GOST R 50030.5.1-2005: Low-voltage switchgear and controlgear. Part 5. Control circuit devices and switching elements. Section 1. Electromechanical control circuit devices
GOST R 50339.0-2003: Low-voltage fuses. Part 1. General requirements
GOST R 50339.1-92: Low-voltage fuses. Part 2. Supplementary requirements for fuses for industrial application
GOST R 50345-2010: Electrical accessories. Circuit-breakers for overcurrent protection for household and similar installations. Part 2. Circuit-breakers for a.c. operation
GOST R 51317.4.2-2010: Electromagnetic compatibility of technical equipment. Electrostatic discharge immunity. Requirements and test methods.
GOST R 51317.4.3-2006: Electromagnetic compatibility of technical equipment. Radio-frequency electromagnetic field immunity. Requirements and test methods.
GOST R 51317.4.4-2007: Electromagnetic compatibility of technical equipment. Immunity to nanosecond impulsive disturbance. Requirements and test methods
GOST R 51317.4.5-99: Electromagnetic compatibility of technical equipment. Microsecond high energy pulse disturbance immunity. Requirements and test methods
GOST R 51317.4.6-99: Electomagnetic compatibility of technical equipment. Immunity to conducted disturbance induced by radio-frequency fields. Requirements and test methods
GOST R 51318.11-2006: Electromagnetic compatibility of technical equipment. Industrial, scientific, medical and domestic (ISMD) high-frequency equipment. Radio disturbance. Limits and methods of measurement
GOST R 51321.1-2007: Low-voltage switchgear and control gear assemblies. Part 1. Type-tested and partially type-tested assemblies. General technical requirements and test methods
GOST R 51731-2001: Electromechanical contactors for household and similar purposes
GOST R 52776-2007: Rotating electrical machines. Rating and performance
GOST R IEC 61508-1-2007: Functional safety of electrical, electronic, programmable electronic safety-related systems. Part 1. General requirements
GOST R IEC 61508-2-2012: Functional safety of electrical, electronic, programmable electronic safety-related systems. Part 2. Requirements for systems
GOST R IEC 61508-3-2012: Functional safety of electrical, electronic, programmable electronic safety-related systems. Part 3. Software requirements
GOST R IEC 61508-4-2012: Functional safety of electrical, electronic, programmable electronic safety-related systems. Part 4. Terms and definitions
GOST R IEC 61508-5-2007: Functional safety of electrical, electronic, programmable electronic safety-related systems. Part 5. Guidelines for methods of the determination of safety integrity levels
GOST R IEC 61508-6-2007: Functional safety of electrical, electronic, programmable electronic safety-related systems. Part 6. Guidelines on the application of GOST R IEC 61508-2-2007 and GOST R IEC 61508-3-2007
GOST R IEC 61508-7-2007: Functional safety of electrical, electronic, programmable electronic safety-related systems. Part 7. Techniques and measures
GOST R ISO 13849-1-2003: Safety of machinery. Safety-related parts of control systems. Part 1. General principles for design
The Document is Referenced By:
GOST 33807-2016: Safety of attractions. General requirements
GOST 33966.1-2016: Escalators and moving walks. Safety requirements for construction and installation
GOST IEC 60309-4-2013: Plugs, socket-outlets and couplers for industrial purposes. Part 4. Switched socket-outlets and connectors with or without interlock
GOST IEC 61095-2015: Electromechanical contactors for household and similar purposes
GOST R 50030.3-2012: Low-voltage switchgear and control gear. Part 3. Switches, disconnectors, switch-disconnectors and fuse-combination units
GOST R 50030.4.2-2012: Low-voltage switchgear and control gear. Part 4. Contactors and motor-starters. Section 2. AC semiconductor motor controllers and starters
GOST R 58604-2019: Unified energy system and isolated energy systems. Thermal power plants. Automated process control systems. Terms of creation. Norms and Requirements
GOST R ISO 22734-2-2014: Hydrogen generators using water electrolysis process. Part 2. Residential applications
Letter 15153/05-DG: About the application of the standards
Protocol 03-14-PR: Meeting of the Working Group on making decisions on the possibility of using national and interstate standards developed on the basis of (instead of) previously valid, to ensure the activities of the Federal Accreditation Service (Rosakkreditatsiya) on accreditation and competence verification of accredited persons of April 29, 2022 N 03-14-pr
|
Customers Who Viewed This Item Also Viewed:
 |
Cylindrical evolvent gears of external engagment. Strength calculation
Language: English |
Unified system for design documentation. Types and sets of design documentation
Language: English |
Loads and impacts
Language: English |
High strength rolled steel. General specification
Language: English |
Food products, food raw materials. Method for determination of the non-steroidal anti-inflammatory drug residue content by high performance liquid chromatography – mass spectrometry
Language: English |
Plywood for general use with outer layers of deciduous veneer. Specifications
Language: English |
 |
|
YOUR ORDERING MADE EASY!
RussianGost.com is an industry-leading company with stringent quality control standards and our dedication to precision, reliability and accuracy are some of the reasons why some of the world’s largest companies trust us to provide their national regulatory framework and for translations of critical, challenging, and sensitive information.
Our niche specialty is the localization of national regulatory databases involving: technical norms, standards, and regulations; government laws, codes, and resolutions; as well as RF agency codes, requirements, and Instructions.
We maintain a database of over 220,000 normative documents in English and other languages for the following 12 countries: Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Mongolia, Russia, Tajikistan, Turkmenistan, Ukraine, and Uzbekistan.
Placing Your Order
Please select your chosen document, proceed to the ‘checkout page’ and select the form of payment of your choice. We accept all major credit cards and bank wire transfers. We also accept PayPal and Google Checkout for your convenience. Please contact us for any additional arrangements (Contract agreements, PO, etc.).
Once an order is placed it will be verified and processed within a few hours up to a rare maximum of 24 hours.
For items in stock, the document/web link is e-mailed to you so that you can download and save it for your records.
For items out of stock (third party supply) you will be notified as to which items will require additional time to fulfil. We normally supply such items in less than three days.
Once an order is placed you will receive a receipt/invoice that can be filed for reporting and accounting purposes. This receipt can be easily saved and printed for your records.
Your Order Best Quality and Authenticity Guarantee
Your order is provided in electronic format (usually an Adobe Acrobat or MS Word).
We always guarantee the best quality for all of our products. If for any reason whatsoever you are not satisfied, we can conduct a completely FREE revision and edit of products you have purchased. Additionally we provide FREE regulatory updates if, for instance, the document has a newer version at the date of purchase.
We guarantee authenticity. Each document in English is verified against the original and official version. We only use official regulatory sources to make sure you have the most recent version of the document, all from reliable official sources.
