1975

RESET FILTERS    Category:   
Product Type:
RTM 26-07-195-75
RTM 26-07-195-75
The order of installation and regulation of typical signaling nodes. Switch type BPT-2
RTM 26-07-196-75
RTM 26-07-196-75
The order of installation and regulation of typical signaling nodes. Sensors DBPM-3, DBKPTM-3a and signaling devices SPKM-3a, SKPUM-D3a-R
RTM 26-07-197-75
RTM 26-07-197-75
The procedure for obtaining a passport for industrial pipe fittings
RTM 26-07-199-75
RTM 26-07-199-75
Test system for testing pipeline valves. Periodic testing. Main provisions
RTM 26-07-200-75
RTM 26-07-200-75
The procedure for the design and application of typical calculations of pipe fittings and actuators for it
RTM 26-07-201-75
RTM 26-07-201-75
Sealing technology of coils of electromagnets
RTM 26-07-202-75
RTM 26-07-202-75
The dependence of the service life of valve valves on the specific pressure on the sealing surface
RTM 26-07-203-75
RTM 26-07-203-75
Surfacing of sealing surfaces of pipeline fittings UONI-13/H1-BK with electrodes UONI-13/H1-BK
RTM 26-07-204-75
RTM 26-07-204-75
Method for calculation of full-lift safety valves of the hung throughput capacity
RTM 26-07-205-75
RTM 26-07-205-75
Climatic tests of pipe fittings
RTM 26-07-206-75
RTM 26-07-206-75
Ball valves. Construction of valve assemblies with fluoroplast-4 seal
RTM 26-08-15-75
RTM 26-08-15-75
Typical control scheme for clamping the upper shaft of the press
RTM 26-08-26-75
RTM 26-08-26-75
Pipeline connections (GOST restriction)
RTM 26-08-32-75
RTM 26-08-32-75
Method of heat engineering calculation of the drying part of paper-board-making and drying machines using computers
RTM 26-12-09-75
RTM 26-12-09-75
Safety valves spring full-lift piston compressors. Calculation methods
RTM 26-158-75
RTM 26-158-75
Automated control systems in the industry of chemical and petroleum engineering "ASU-Himmash" and ASUP. Information Support. Basic concepts. Terms and Definitions
RTM 26-208-75
RTM 26-208-75
Orghosnast unified
RTM 26-209-75
RTM 26-209-75
Research and development reports. General requirements
RTM 26-210-75
RTM 26-210-75
Examples of execution of drawings of products of chemical and petroleum engineering
RTM 26-211-75
RTM 26-211-75
System of operational production planning, accounting and dispatching in chemical and petroleum engineering

All Codes and Regulations

All Categories

Send us a message Expand Collapse

Leave your message in the form below, and we will write back by e-mail!